Overview
The Baer Brakes ReMaster 6801297LP is a 4-bolt Mopar master cylinder with a 0.9375 inch (15/16 inch) bore and left side outlet ports. Its 4-bolt firewall flange suits many early Mopar applications, and the cylinder works with most long and short boosters or manual brake setups.
Built from one piece of 6061 T6 billet aluminum, the body carries a gray anodized finish with black anodized caps and lid. Its outlet ports can be plumbed with inverted flare fittings using the included removable brass seats, banjo fittings, or straight fittings, and the dual integral reservoir has two machined, knurled caps for filling.
Key features
- One-piece, fully machined 6061 T6 billet body
- Left side ports with two 3/8-24 outlet ports
- 4-bolt Mopar firewall mounting bracket
- Billet top held by six allen screws
- Knurled screw-on caps for filling without spillage
- Banjo, inverted flare, or straight outlet fittings
- Anodized finish with laser-etched logos
- Optional proportioning valves are also offered
Left side plumbing basics
Left side outlets place the lines on the driver side of the firewall, so route them clear of the exhaust, steering components and moving linkage. Allow enough slack for engine movement and suspension travel, but avoid loops that trap air or collect fluid. Support longer runs with clips so the lines do not rub against the body.
Hose and line length should be set before the final tightening. Measure the run from each outlet to the caliper or proportioning valve and cut lines to suit rather than forcing a bend. Once everything is tight, check each joint with the system under pressure and look for fluid at the connections before driving.
- Keep lines away from heat sources
- Use clips at regular intervals along longer runs
- Check clearance at full steering lock
Specifications
| Brand | Baer Brakes |
|---|---|
| Part number | 6801297LP |
| UPC | 844165052081 |
| Series | ReMaster |
| Sold as | Each |
| Bore size | 0.9375 inch (15/16 inch) |
| Body material | 6061 T6 billet aluminum |
| Body finish and color | Anodized gray |
| Cap and lid finish | Anodized black |
| Flange type | 4 bolt Mopar |
| Port exit | Left side |
| Outlet port quantity | 2 |
| Outlet port size | 3/8-24 inch |
| Outlet port fittings | Banjo without brass seat, 3/16 inch inverted flare and tube nuts with brass seat |
| Reservoir type | Dual, integral, 6061 T6 billet aluminum |
| Reservoir size | 7 oz per reservoir; fill to 75 percent or 5.25 oz per reservoir |
| Removable seats | Yes |
| Area | 0.69 |
| Stroke | 1.1 |
| Grade | Premium |
| Country of origin | USA |
Vehicle fitment
The flange is 4-bolt Mopar. Match the year, model and trim to your vehicle before buying.
Compare bore, flange and left port placement with your current cylinder before buying.
Installation notes
Settle on the fitting style first, since the brass seats and tube nuts included match the inverted flare option. Check hose routing and line length against the left side ports before the cylinder is mounted to the firewall bracket. The bleeder screw and hoses are not supplied, so have them on hand before bleeding the brakes.
What’s included
One master cylinder assembly with two brass seats, two tube nuts, two knurled screw-on caps, and a dual integral reservoir.
Not included: You will need separate parts for the booster, the bleeder screw and hoses, the brake pressure switch, the warning light connector, the sensor, the mounting hardware, and the gasket or seal.













