Overview
The Baer Brakes 6801305LP is a polished Remaster master cylinder built for left side ports, with a 1-1/8 inch bore and a 4-bolt Mopar mounting flange. It is a one-piece unit machined from 6061 T6 billet aluminum, with billet caps that screw on for filling.
The two 3/8-24 inch outlet ports take inverted flare fittings with removable brass seats, banjo fittings or straight fittings. An optional proportioning valve is available. The mounting flange fits early Mopar applications.
Key features
- Left side ports
- 4-bolt Mopar firewall mounting bracket
- One-piece 6061 T6 billet aluminum body
- Outlet ports suit inverted flare, banjo or straight fittings
- Machined and knurled screw-on caps
- Polished finish on body, caps and lid
- Dual integral reservoirs
Planning the line routing
Port orientation controls where each brake line leaves the cylinder, so the routing plan should come first. A left side outlet can shorten or lengthen the run to the proportioning valve and wheel lines, and that change affects how hoses and rigid tubing sit around the engine bay. Mock up the lines with the cylinder in place before drilling or welding any bracket.
Keep the outlet fittings clean and undamaged, since a scored seat can leak even when the tube nut is tight. Inverted flare fittings need the brass seats seated squarely, while banjo fittings rely on crush washers to seal. After routing, bleed each circuit fully and check for leaks while the pedal is held under pressure.
- Confirm clearance from steering shafts and exhaust heat
- Support long hard lines with clamps to prevent vibration cracks
- Replace worn hoses that flex near the cylinder
- Keep the reservoir cap closed to limit moisture and debris
Specifications
| Brand | Baer Brakes |
|---|---|
| Part number | 6801305LP |
| UPC | 844165052180 |
| Series | ReMaster |
| Finish | Polished body, caps and lid |
| Body material | 6061 T6 billet aluminum |
| Bore size | 1.125 inch (1-1/8 inch) |
| Port exit | Left side |
| Outlet ports | 2 |
| Outlet port size | 3/8-24 inch |
| Outlet fittings | Banjo without brass seat, or 3/16 inch inverted flare and tube nuts with brass seat |
| Flange type | 4-bolt Mopar |
| Reservoir | Integral dual, 6061 T6 billet aluminum |
| Reservoir size | 7 oz per reservoir; fill to 75 percent or 5.25 oz per reservoir |
| Removable seats | Yes |
| Stroke | 1.3 |
| Cap included | Yes |
| Mounting hardware included | No |
| Bleeder screw included | No |
| Quantity | One master cylinder assembly |
| Grade | Premium |
| Country of origin | USA |
Vehicle fitment
The 6801305LP has no fitment listed. Compare its 4-bolt flange and 1-1/8 inch bore with your own setup, since no years, makes or models are named.
Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Port exit matters on this version: confirm the left side outlet lines up with your line routing before the cylinder is bolted to the firewall. Baer gives a 75 percent fill, or 5.25 oz per reservoir, for the integral reservoirs. Finish the job with a full bleed and a pedal check.
What’s included
One master cylinder assembly with reservoir and cap, two brass seats and two tube nuts.
Not included: bolts, bleeder screw, bleeder hoses, brake pressure switch, booster, gasket or seal and sensor.














