Overview
The Baer Brakes 6801301RP is a Remaster master cylinder with a 1 inch bore, a black anodized finish and right side ports, built for a 4-bolt Mopar firewall mount. It is a compact, one-piece body machined from 6061 T6 billet aluminum and suits many early Mopar applications. It works with most long and short boosters as well as manual brake setups.
Anyone looking for a right-port, 4-bolt Mopar master cylinder with dual reservoirs will find the port exit on the right side. Its two 3/8-24 outlet ports accept inverted flare fittings with removable seats, banjo style fittings or straight fittings, and the billet top is held in place by 6 allen screws.
Key features
- Fully machined 6061 T6 billet aluminum body
- 4-bolt Mopar firewall mounting bracket
- Right side ports for right-exit plumbing
- Dual integral reservoir with knurled, screw-on caps for filling without spillage
- Outlet ports accept inverted flare (with removable seats), banjo or straight fittings
- Black anodized finish, with laser-etched logos on anodized Remasters
Choosing the right setup
A master cylinder converts pedal force into hydraulic pressure for all four brakes, so its bore, port layout and fitting style have to match the lines already on the vehicle. Start with the firewall pattern, then confirm the booster type and whether the rear brakes use drums or discs. Right and left port versions are not interchangeable without re-routing lines.
Dual reservoir designs keep the front and rear circuits separate, so a leak in one half leaves the other half working. Keep the fluid level between the marks when topping up, and inspect the reservoir seals during service. Brake fluid absorbs moisture over time, so replace it on the schedule suited to your vehicle.
- Match port side to existing brake line routing
- Use banjo or inverted flare fittings that suit each line end
- Recheck the pushrod length if the booster stack changes
Specifications
| Brand | Baer Brakes |
|---|---|
| Part number | 6801301RP |
| UPC | 844165052173 |
| Series | ReMaster |
| Bore size | 1 inch (1.00 inch) |
| Body material | 6061 T6 billet aluminum |
| Body finish | Black anodized |
| Caps and lid finish | Black anodized |
| Flange type | 4 bolt Mopar |
| Port exit | Right side |
| Outlet port quantity | 2 |
| Outlet port size | 3/8-24 inch |
| Outlet port fittings | Banjo without brass seat, 3/16 inch inverted flare and tube nuts with brass seat |
| Removable seats | Yes |
| Reservoir | Dual, integral, 6061 T6 billet aluminum |
| Reservoir size | 7oz per reservoir, fill to 75 percent or 5.25oz per reservoir |
| Stroke | 1.1 |
| Area | 0.78 |
| Volume ratio | 0.0840277777777778 |
| Country of origin | USA |
| Sold as | Each |
Vehicle fitment
The 6801301RP is designed for early Mopar applications with a 4-bolt firewall mount. Confirm the bolt pattern and firewall clearance against your vehicle before installing it.
Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Bleeder screws, bleeder hoses, mounting hardware, the brake booster and the pressure switch are not included, so have them ready before starting. The two brass seats and two tube nuts support the inverted flare outlet. Brake hydraulic work is safety-critical: bleed the system completely after installation and test pedal firmness before driving.
What’s included
- 1 master cylinder assembly with integral dual reservoir
- Master cylinder cap
- 2 brass seats and 2 tube nuts
Not included: bleeder screws, bleeder hoses, brake booster, brake pressure switch, sensor, gasket or seal, mounting hardware.














