Overview
The Baer Brakes 6805201LP is a polished ReMaster master cylinder with a 7/8 inch bore and left side ports, designed for a 2-bolt GM/Ford firewall mount. The one-piece body is machined from 6061 T6 billet aluminum, and the polished surface runs across the body, caps and lid. Baer notes compatibility with most long and short boosters, bullet types included, and with manual brake applications.
The two 3/8-24 outlets accept inverted flare fittings with removable brass seats, banjo fittings or straight fittings, so the line style can be matched to the brake plumbing. Confirm fit for your vehicle’s year, model and trim before ordering.
Key features
- Left side ports for a left-hand plumbing layout
- Polished 6061 T6 billet aluminum body, caps and lid
- Two pistons in a 7/8 inch bore
- Outlet fitting choices: inverted flare, banjo or straight
- Removable brass seats for the inverted flare option
- Mounting bracket included for the 2-bolt GM/Ford flange
- Integral dual reservoir, 7oz per reservoir
Bleeding and topping up
A remote master cylinder starts the hydraulic circuit, so air trapped at the cylinder or in the lines will show up as a soft pedal. Fill both reservoir chambers before the first bleed and keep them above the minimum line throughout the process. Work through each wheel in the sequence your brake service procedure gives, starting farthest from the cylinder, and close each bleeder before the fluid level drops far enough to draw air back in.
Brake fluid absorbs moisture over time, so a sealed reservoir with fresh fluid keeps the cylinder working as intended. Inspect the caps and reservoir seals whenever the lines are opened, and replace any cap that no longer seats cleanly. A pedal that sinks slowly under steady pressure often points to a leak at a fitting or a worn seal inside the bore rather than a fluid problem.
- Use only the brake fluid type approved for your vehicle
- Check each outlet fitting for seepage after the first pedal cycles
- Re-check the mounting bolts after the first few drives
Specifications
| Brand | Baer Brakes |
|---|---|
| Part number | 6805201LP |
| UPC | 810215393046 |
| Series | ReMaster |
| Bore size | 7/8 inch (0.875 inch), straight bore |
| Pistons | 2 |
| Material | 6061 T6 billet aluminum |
| Finish | Polished body, caps and lid |
| Port exit | Left side |
| Outlet port size | 3/8-24 inch, 2 ports |
| Outlet fittings | Banjo without brass seat; 3/16 inch inverted flare and tube nuts with brass seat |
| Reservoir | Integral, dual |
| Reservoir size | 7oz per reservoir; fill to 75 percent or 5.25oz per reservoir |
| Flange | 2-bolt GM/Ford, 2 mounting holes, hole diameter 0.4 |
| Pedal rod ID | 0.475 |
| Stroke | 1.1 |
| Mounting bracket included | Yes |
| Mounting hardware included | No |
| Quantity | 1, sold individually |
| Country of origin | USA |
Vehicle fitment
Confirm your vehicle’s year, model and trim before ordering.
Installation notes
A spacer, part number 6260258, may be required on certain long push-rod hydro-boost or vacuum booster setups to keep the Remaster off the booster push rod. Check push-rod length and clearance before final mounting. The reservoirs are listed at 7oz each, filling to 75 percent or 5.25oz per reservoir, which is the level to use when topping up after bleeding.
What’s included
The set includes one polished master cylinder assembly with reservoir and caps, a mounting bracket, two brass seats and two tube nuts.
Not included: brake booster, push rod, mounting hardware, bleeder screws and brake pressure switch or sensor.














