Overview
The Baer Brakes 6805147 is a billet aluminum pressure residual valve with a -3AN male fitting and a 2-pound pressure rating, built for disc brake systems where the master cylinder sits below or level with the calipers. A pressure residual valve keeps a small amount of line pressure in the circuit in the situations where that pressure is needed. It is a brake hydraulic component, and it is chosen by brake circuit type and master cylinder position rather than by a specific vehicle.
The 2-pound valve is the version for disc brakes when the master cylinder is mounted below or level with the calipers. Without that residual pressure, brake fluid can drain back toward the master cylinder and lead to excessive pedal travel. A four-wheel disc brake vehicle uses two of these valves, one in the front circuit and one in the rear circuit. Drum brake circuits use a different 10-pound valve regardless of where the master cylinder sits, so this 2-pound unit is not the drum choice.
Key features
- 2-pound pressure rating for disc brake circuits
- -3AN male inlet fitting
- Billet aluminum body with a black anodized finish
- Single residual valve, box count 1
- Frame mounts are not included and are sold separately
Choosing by brake layout
A brake residual valve sits in the hydraulic line between the master cylinder and the brake circuit. Its job is to hold a small amount of pressure in the line so that fluid stays close to the calipers, which helps keep pedal feel consistent when the brakes are applied again. Whether a valve is needed depends on the braking system design, so the choice starts with knowing where the master cylinder sits relative to the calipers and whether the rear brakes are drum or disc.
Residual valves are often replaced along with brake lines, fittings and the master cylinder during a brake rebuild. If the old valve is seeping fluid, sticking, or the pedal feels soft after service, inspect the valve body, threads and seals before refilling. Keep the fluid clean and fresh, since contamination can damage internal seals over time. Anodized finishes help a body resist surface wear, but mounting hardware should still be checked during routine brake inspections.
- Check the fittings for fluid seepage after bleeding
- Confirm the valve is mounted securely before driving
- Inspect the line flare for damage before connecting
- Match the fitting size to the line or adapter first
Specifications
| Brand | Baer Brakes |
|---|---|
| Part number | 6805147 |
| UPC | 844165052388 |
| Pressure | 2 pounds |
| Inlet fitting | -3AN male |
| Material | Billet aluminum |
| Finish | Black anodized |
| Quantity | 1 |
| Country of origin | USA |
| Mounts included | No |
Vehicle fitment
It is chosen by brake circuit type and master cylinder position rather than by a specific make, model or year. Match it to your braking layout rather than to a vehicle name.
Installation notes
Billet aluminum frame mounts are not included, so plan a separate way to hold the valve in place before you start. Confirm that the -3AN male end matches the line or adapter you are connecting. Brake work changes stopping performance, so bleed the hydraulic system and test pedal firmness before driving.
What’s included
One Baer Brakes pressure residual valve (1x Residual Valve).
Not included: Billet aluminum frame mounts, which are sold separately.












