Overview
The Baer Brakes 6805148 is a 2 lb pressure residual valve built from billet aluminum, with a 3/8-24 IF female inlet. Residual valves hold a small amount of line pressure in the brake system, which helps in situations where the pressure would otherwise drop off. This is the 2 pound rating, the version Baer offers for disc brake circuits.
Use it where the master cylinder is mounted below or level with the calipers, because that layout can let fluid drain back toward the master cylinder and cause excessive pedal travel. A four-wheel disc vehicle uses two of these valves, one in the front circuit and one in the rear circuit. Drum brake circuits take the 10 lb version instead, whatever the master cylinder location, so the rating always follows the circuit type rather than the vehicle.
Key features
- 2-pound pressure rating for disc brake circuits
- 3/8-24 IF female inlet fitting
- Billet aluminum body
- Black anodized finish
- Premium grade type
- Supplied as one valve, quantity 1
- Intended for systems where the master cylinder sits at or below caliper level
How residual pressure works
A residual valve holds a small amount of pressure in its circuit so fluid does not drain back toward the master cylinder when the pedal is released. That retained pressure helps the lines and caliper seals stay in a steady state and keeps the pedal consistent. The valve is only one part of the circuit, so its job depends on how the rest of the layout is built.
Drum and disc circuits use different ratings for good reason. Drum brakes need more residual pressure to keep the shoes in light contact with the drum, while disc systems use less. Changing the valve in one circuit without reviewing the other can upset the balance between front and rear.
- Inspect the valve body for seepage at the fitting
- Keep the valve upright and clear of heat sources
- Bleed the circuit after any valve replacement
- Note which circuit each valve serves before removal
Specifications
| Brand | Baer Brakes |
|---|---|
| Part number | 6805148 |
| UPC | 844165052395 |
| Pressure | 2 pounds |
| Inlet | 3/8-24 IF female |
| Material | Billet aluminum |
| Finish | Black anodized |
| Mounts included | No |
| Grade type | Premium |
| Quantity | 1 |
| Box count | 1 |
| Emission code | 6 |
| Country of origin | USA |
Vehicle fitment
This valve is intended for disc brake circuits where the master cylinder sits at or below caliper level. Choose the rating by brake circuit: the 2 pound valve for disc circuits and the 10 lb valve for drum circuits. Confirm fit for your vehicle’s year, model and trim before ordering.
Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Count the disc circuits in your system first, since a four-wheel disc layout uses two 2 pound valves. Billet aluminum frame mounts are not included, so decide on a mounting method before you start the line work.
What’s included
One 2 pound residual valve with a 3/8-24 IF female inlet, quantity 1.
Not included: billet aluminum frame mounts, which are available separately.












