Overview
The Baer Brakes 6801329LP is a gray anodized ReMaster master cylinder with left side ports and a 1.125 inch (1-1/8) bore, designed for the 1999-2004 Ford Mustang hydroboost setup. Its two bolt flange sits on the SN95 hydroboost firewall bracket, so the cylinder suits that installation only.
Baer Brakes machines the body from 6061 T6 billet aluminum and finishes the caps and lid in black anodized. Outlet ports accept inverted flare fittings with removable brass seats or banjo style fittings. The dual integral reservoirs are sized at 7oz per reservoir, and filling to 75 percent is the stated guide.
Key features
- Left side port exit on a 1.125 inch bore
- Gray body with black anodized caps and lid
- Two-bolt flange for the 1999-04 SN95 Mustang hydroboost bracket
- Billet 6061 T6 aluminum construction
- Knurled, screw-on caps for easy filling
Hydroboost system basics
A hydroboost system uses fluid pressure from the power steering pump to assist braking, so the master cylinder and booster must work together. A failure in either part can change pedal feel, so the two are often checked as a set during a brake job. Pedal travel that changes over time or a pedal that sinks under steady pressure are common reasons to inspect the system.
Before replacing the cylinder, check the hydroboost bracket, the booster pushrod adjustment and the condition of the reservoir and lines. Fill the reservoir only to the stated level, and keep it covered during service so dirt does not enter the circuit. After installation, bleed the system thoroughly and test the pedal at a stop before driving.
- Inspect the bracket and pushrod adjustment
- Keep the reservoir covered during service
- Test pedal feel at a stop before driving
Specifications
| Brand | Baer Brakes |
|---|---|
| Part number | 6801329LP |
| UPC | 844165054269 |
| Series | ReMaster |
| Bore size | 1.125 inch (1-1/8) |
| Material | 6061 T6 billet aluminum |
| Body color | Gray |
| Body finish | Anodized |
| Caps and lid color | Black |
| Caps and lid finish | Anodized |
| Port exit | Left side |
| Outlet ports | 2 at 3/8-24 |
| Outlet fittings | Banjo without brass seat; 3/16 inch inverted flare with tube nuts and brass seat |
| Reservoir | Dual integral; 7oz per reservoir, fill to 75 percent or 5.25oz per reservoir |
| Flange | 2 bolt, 1999-04 SN95 Mustang hydroboost specific |
| Stroke | 1.3 |
| Country of origin | USA |
Vehicle fitment
The cylinder is made for the 1999-2004 Ford Mustang Cobra hydroboost application, and its flange is built for the 1999-04 SN95 hydroboost bracket. Check the model year and bracket before ordering.
Non hydroboost Mustangs and model years outside 1999-04 are not what this flange is designed for. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Verify the SN95 hydroboost bracket before fitting the cylinder, since the flange is shaped for it. Plan the left side outlet plumbing before tightening fittings, and use the brass seats and tube nuts only for inverted flare connections. Fill to the 75 percent level as specified, and keep the caps screwed on securely.
What’s included
One Remaster master cylinder assembly with reservoir, caps, two brass seats and two tube nuts.
Not included: The package omits the brake booster and mounting hardware, and it has no bleeder screw, bleeder hoses or pressure switch.













