Overview
The Titan Tanks 57 Gallon Extra Capacity Fuel Tank, part number 7010211, is an extra heavy duty midship replacement tank made of military grade cross-linked polyethylene. It fits 2011 General Motors pickups with Crew Cabs and 6.5 ft beds, including 2011–2016 GMC Crew Cab short bed trucks.
The tank looks very close to the original equipment tank and hangs about 1.5 inches below the bottom of the original tank shield.
Key features
- Extra capacity, extra heavy duty midship design
- Military grade cross-linked polyethylene, known as XLHDPE
- Low fuel trap design
- Looks very similar to the original equipment tank
- Hangs approximately 1.5 inches below the bottom of the original tank shield
Before mounting a midship tank
A midship tank sits between the axles, so its fill neck, filler hose and vent lines need to route cleanly around the frame, driveshaft and exhaust. Before you lift the old tank, drain as much fuel as you safely can, disconnect the battery and mark each fuel and vent connection so the new tank goes back the same way. Tank position matters because a lower hang leaves less room for road debris, so look for any dents in the shield after installation.
Fuel tanks in this class are often replaced with the sending unit, pump seal and filler hose at the same time, since the work exposes them. Inspect the old rubber bushings and straps for cracking or flattening. Look for seepage at the fuel line fittings and a fuel smell after the first few trips, and re-check strap tension after a short drive, because new bushings settle slightly.
Specifications
| Brand | Titan Tanks |
|---|---|
| Part number | 7010211 |
| UPC | 848135000041 |
| Capacity | 57 gallons |
| Material | Military grade cross-linked polyethylene (XLHDPE) |
| Mounting hardware | Zinc-coated steel strap set, extruded rubber mounting bushings |
| Drop below original shield | Approximately 1.5 inches |
Vehicle fitment
It fits 2011 General Motors pickups with Crew Cabs and 6.5 ft beds, including 2011–2016 GMC Crew Cab short bed trucks. Confirm fit for your vehicle’s year, model and trim before ordering.
Confirm fit for your vehicle’s year, model and trim before ordering, especially for regular cab trucks or other bed lengths.
Installation notes
Measure clearance to the shield and frame before mounting, since the tank hangs only about 1.5 inches below the original shield. The kit uses a zinc-coated steel strap set and rubber bushings, installed with the tank.
What’s included
Zinc-coated steel mounting strap set, extruded rubber mounting bushings and accessories.









