Overview
The Specialty Products 82387 is a heavy-duty caster and pinion cam kit for the 2013–2019 Ram 2500 and 3500. It replaces frozen or worn lower control arm bolts with replacement adjusters that allow caster and pinion angle changes of plus or minus 2.0 degrees.
The bolts are built for heavy-duty Ram use and carry a corrosion resistant coating. The kit can be used to dial in the alignment or to correct the angles after a suspension lift. The finish is hex chromate free and carries a 700 hour salt spray test rating.
Key features
- Replacement lower control arm adjusters
- Plus or minus 2.0 degrees of caster and pinion adjustment
- High strength bolts
- Corrosion resistant coating
- Hex chromate free finish, with a 700 hour salt spray test
Heavy-duty axle service tips
Heavy-duty Ram axles work under higher loads, so the lower control arm mounts see more stress over time. Frozen or worn bolts are often the reason caster and pinion angles drift, and replacing them with adjusters allows the setting to be dialed in again. Work on the bolts with penetrating oil and patience, since forcing a seized bolt can damage the bracket.
The adjusters are the part of the job that sets the final angles, so take care with torque and the alignment after installation. A truck that carries a heavy load or pulls a trailer may need the angles checked more often. Inspect the control arm bushings and brackets during the job, and replace any part that shows wear.
- Use penetrating oil and time on frozen bolts
- Inspect control arm bushings during the job
- Torque fasteners to the correct value for the truck
- Recheck caster and pinion after the first trailer trip
Specifications
| Brand | Specialty Products |
|---|---|
| Part number | S/P82387 |
| Adjustment range | Plus or minus 2.0 degrees, caster and pinion |
| Quantity | One kit per axle |
| Finish | Hex chromate free, corrosion resistant |
| Salt spray test | 700 hours |
| Fitment | Direct fit |
Vehicle fitment
The kit fits the 2014–2019 Ram 2500 in Big Horn, Laramie, Laramie Limited, Laramie Longhorn, Limited, Lone Star, Outdoorsman, Power Wagon, SLT and Tradesman trims, and the 2013–2019 Ram 3500 in Big Horn, Laramie, Laramie Limited, Laramie Longhorn, Limited, Lone Star, SLT, ST and Tradesman trims.
The 2013 Ram 2500 is not covered, and other Ram model years are not covered. Confirm fit for your vehicle’s year, model and trim before ordering.
Installation notes
One kit is needed for each axle. The replacement adjusters go in place of the frozen or worn lower control arm bolts, and the alignment should be set after the caster and pinion angles are changed.







