Overview
The Specialty Products 82395 is a caster and pinion cam kit for the Dodge Ram 1500 from 1994 to 1999. It replaces the non-adjustable or corroded factory caster bolts, and it allows 1.5 degrees of caster and pinion angle change to tune the alignment.
The kit is fitted to 1994–1999 Ram 1500 trucks. It lets the owner set caster and pinion angles for tracking and for axle and driveshaft position, whether the truck is lifted or at stock height.
Key features
- Replaces non-adjustable or corroded factory caster bolts
- Plus or minus 1.5 degrees of adjustment for caster and pinion
- 1.8 inch cam plates
- One kit required per axle
- Usable on lifted or stock trucks
Caster and pinion explained
Caster is the tilt of the steering axis as seen from the side, and it affects steering return and straight-line stability. Pinion angle is the angle of the differential pinion relative to the driveshaft, and it affects driveline vibration. Both angles can shift when the truck is lifted or when worn caster bolts allow the axle to move, which is why adjustment matters.
Before adjusting, inspect the caster bolts and the surrounding brackets for corrosion or cracks, because the cam plates rely on solid mounting points. Set the angles with an alignment and check the driveline afterward. A change in one angle often affects the other, so both are worth checking together.
- Inspect the caster bolts and brackets first
- Check the driveline for vibration after adjusting
- Set caster and pinion together when possible
- Recheck the alignment after the first drive
Specifications
| Brand | Specialty Products |
|---|---|
| Part number | S/P82395 |
| Adjustment range | Plus or minus 1.5 degrees, caster and pinion |
| Cam plate size | 1.8 inch |
| Quantity | One kit per axle |
| Fitment | Direct fit |
Vehicle fitment
The kit fits the 1994–1999 Dodge Ram 1500 in Base, LT, Laramie, SS/T 5.9L, ST, Sport and WS trims.
Other Ram model years are not on the list. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
One kit is needed for each axle. The cam plates replace the caster bolts, so the bolts being replaced must be the non-adjustable or corroded factory ones. After installation, the alignment should be set and checked.










