Overview
The Rough Country N3 dual steering stabilizer (part number R/C8749630) fits the 1999–2004 Jeep Grand Cherokee (WJ). It only fits models equipped with a 4-inch suspension lift and does not fit stock-height vehicles.
The stabilizer is designed to restrain bump steer and front-end vibration, which helps steering components last longer. Brackets are included with the kit.
Key features
- Dual N3 stabilizer
- Brackets included
- Only fits models with a 4-inch suspension lift
- Easy bolt-on installation
- Reduces bump steer
- Chrome hardened 18mm piston rod
Lift height and fit
A steering stabilizer works best when the steering geometry matches the lift it was built for. Changing the lift, the tire size or the axle position can move the stabilizer angle, so the damping may feel different than expected. This matters most on washboard roads and at highway speeds, so plan any suspension change around the stabilizer, not after it.
Grand Cherokee WJ owners often replace the steering stabilizer alongside tie rods, drag link ends and ball joints. Replacing worn joints during the same job avoids uneven load on the new unit. After installation, drive at low speed on a rough road and listen for knocks or steering wobble, then recheck the mounts.
- Check tie rods and ball joints
- Confirm lift height before mounting
- Recheck brackets after a week of driving
Specifications
| Brand | Rough Country |
|---|---|
| Part number | R/C8749630 |
| Series | N3 |
| Single or dual | Dual |
| Brackets | Included |
| Lift required | 4 in suspension lift |
| Fitment | Direct fit |
Vehicle fitment
It fits the 1999–2004 Jeep Grand Cherokee (WJ) in the Laredo, Limited, Overland, Special Edition and Sport trims.
The list does not include the ZJ Grand Cherokee or the other Jeep models. Confirm your vehicle’s year, model and trim before ordering.
What’s included
A dual N3 steering stabilizer with brackets.











