Overview
The Revtek 432 is a 3 inch lift kit with coil spring spacers at the front and rear. It fits the 2010–2018 Toyota 4Runner and the 2010–2014 Toyota FJ Cruiser, and it includes rear shocks. The split spacer design makes room for tires up to 33 inches.
The split spacer design allows larger tires, and the kit installs without cutting or welding. The factory steering components are not modified. The kit does not fit vehicles with air leveling, X-REAS or TRD Pro equipment.
Key features
- Split spacer design at the front and rear, which Revtek says keeps stock suspension geometry
- Room for tires up to 33 inches
- Rear shocks included
- No modification of original steering components
- No cutting or welding needed
- Lift height range of 2.5 to 3.5 inches
Checking the setup before installation
Spacer lifts raise the body on the existing springs and suspension components, so the original parts stay in use. On a 4Runner or FJ Cruiser this keeps most of the stock geometry, but the added height still changes the angles of the driveshafts and the steering linkage slightly. These changes are normal for this type of lift and are usually easiest to notice at higher speeds or under heavy braking.
Because the wheels sit further from the fenders, larger tires need the rest of the vehicle checked too. Brake lines, sensor wires and the front driveshaft angles are worth a look after the first drives, and an alignment is a sensible step after any height change. Shock length matters as well, so review whether the included rear shocks suit the new ride height.
- Re-torque suspension bolts after the first few trail runs
- Check brake line and sensor wire length after installation
- Recheck wheel alignment once the lift is in place
- Inspect spacers for cracked rubber during routine service
Specifications
| Brand | Revtek |
|---|---|
| Part number | 432 |
| UPC | 811323011259 |
| Lift | 3 inch |
| Lift height range | 2.5 to 3.5 inches |
| Suspension type | Spacer |
| Front lift | Coil spring spacers |
| Rear lift | Coil spring spacers |
| Shocks | Rear shocks included |
| Tire clearance | Up to 33 inches |
Vehicle fitment
The kit fits the 2010–2018 Toyota 4Runner and the 2010–2014 Toyota FJ Cruiser. It does not fit air leveling, X-REAS or TRD Pro equipped models. Match the year, model and trim of your vehicle against these before ordering.
The kit does not fit air leveling, X-REAS or TRD Pro equipped models. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
The kit needs no cutting or welding and no changes to the steering components, so it is a bolt-in spacer installation. Tire choice should be checked against the rest of the build, since the clearance depends on the complete setup.
What’s included
Rear shocks are included, and the coil spring spacers are used at both the front and the rear.








