Overview
The Fabtech K1045 is a 6-inch RTS (Raised Torsion Suspension) lift for the 2001–2010 Chevrolet Silverado and GMC Sierra 2500 HD and 3500 trucks, including the 2007 Classic versions. Its torsion bar brackets hold the bars in the stock location instead of letting them hang low, which Fabtech says gives more ground clearance at the frame.
The torsion bar brackets are patent pending, and the unitized bracketry reduces installation time and adds strength. The high arched crossmembers are made of 1/4-inch thick steel with tubular cross braces, and a 1/4-inch steel front differential skid plate is included. The system was tested on and off road to set bump stop engagement, torsion bar location and shock valving.
Key features
- 6-inch lift height, range 5 to 6.99 inches
- Torsion bars kept in the stock location
- Patent pending torsion bar brackets.
- Unitized bracketry
- 1/4-inch thick steel high arched crossmembers
- 1/4-inch thick steel front differential skid plate
Torsion bar care after lifting
Torsion bars carry the weight of the front end, so any change in their position affects ride height, alignment and bump stop contact. After a lift, the bars should be checked for even height on both sides and for any sign of rubbing against the frame or crossmember. A raised bar set keeps more of its travel clear of the ground, but it still needs room to move through full suspension compression.
Bump stops and the carrier bearing bracket are the parts most often disturbed during an install. Check that the bump stops seat squarely and that the carrier bearing has its full range of motion. Retighten all fasteners after the first few drives, since new brackets can settle under load. Worn or cracked bump stops should be replaced rather than reused, because a damaged stop can cause harsh bottoming.
Specifications
| Brand | Fabtech |
|---|---|
| Part number | K1045 |
| UPC | 70000540620 |
| Lift height | 6 inches (range 5 to 6.99 inches) |
| Suspension type | Knuckle |
| Torsion bar setup | Raised torsion bar brackets in the stock location |
| Crossmembers | 1/4-inch thick steel with tubular cross braces |
| Skid plate | 1/4-inch thick steel front differential |
| Rear lift method | Lift blocks and U-bolts |
| Shocks | Performance shocks included |
Vehicle fitment
It fits 2001–2010 Chevrolet Silverado 2500 HD and 3500 models, the 2007 Silverado 2500 HD Classic and 3500 Classic, the 2007–2010 Silverado 3500 HD, and the GMC Sierra equivalents in the same years.
The list does not cover the 1500 trucks or years outside 2001–2010. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
The unitized bracketry reduces installation time. The kit includes sway bar end links, a differential skid plate, a carrier bearing relocation bracket and a bump stop relocation bracket, so the carrier bearing and the bump stops are relocated during the install.
What’s included
RTS torsion bar brackets, high arched crossmembers, the front differential skid plate, sway bar end links, a carrier bearing relocation bracket, a bump stop relocation bracket, rear lift blocks with U-bolts and performance shocks.












