Overview
The Recon 60-inch Line of Fire tailgate light bar, product number 26411, is a 60-inch LED light bar that mounts in the space between a pick-up truck or SUV bumper and its tailgate or rear door. It is universal fit, so it is not built around one make, model or year.
The bar is street legal and approved for use by the National Highway Traffic Safety Administration (NHTSA). It uses 3mm diode LED technology rather than small SMD-type LEDs, and it is offered in white and red.
Key features
- Plug and play: connects straight into a standard flat 4-pin trailer light socket
- Alternative hard-wire connection to factory taillight wiring, described by Recon as permanent
- Extra strong 3M adhesive tape mounting
- Mounts in the space just above the bumper and below the tailgate or rear door
- White and red colorway
- 3mm diode LED technology
- Approved for street use by NHTSA.
Choosing a tailgate light setup
Tailgate light bars sit in a narrow gap that is often hidden by the bumper and the rear door, so the gap size decides whether a bar fits cleanly. Before buying, measure the space on your own truck or SUV, paying attention to step bumpers, tow hitches or tailgate seals close to the mounting spot. Take a few photos so you can compare them with the bar’s footprint before you commit.
Wiring choice matters as much as mounting. A plug-in connection suits a trailer light socket and is easy to remove later. Hard-wiring is more permanent and ties into the rear lighting circuit, so plan for fused protection and clean routing away from moving parts. Tailgate-mounted lights also take road spray, so check the seal around the connector after the first few wet drives.
- Check gap clearance before ordering
- Route wiring away from the tailgate hinge
- Re-check the adhesive bond after the first week
Specifications
| Brand | Recon |
|---|---|
| Product number | 26411 |
| UPC | 182852000411 |
| Length | 60 in |
| Colors | White and red |
| LED type | 3mm diode |
| Connection | Standard flat 4-pin trailer light connector, or hard-wired to factory taillight wiring |
| Mounting | 3M adhesive tape |
| Fitment type | Universal fit |
Vehicle fitment
It is universal fit across the pick-up truck and SUV market in the U.S., so it is not vehicle-specific. Mounting room between the bumper and the tailgate or rear door is the main sizing question for any vehicle.
Confirm your vehicle’s year, model and trim before ordering. Measure the gap above the bumper and below the tailgate or rear door on your own vehicle before ordering.
Installation notes
The bar installs in minutes. For plug and play use, connect it to a standard flat 4-pin trailer light connector. For a permanent setup, hard-wire it to factory taillight wiring, which means splicing into the rear lighting circuit. Fused relay wiring is the usual protection for that kind of connection, and a qualified installer is the safer choice for that step. Press the 3M adhesive tape onto a clean, dry surface. Check local road-use rules for rear lighting before you drive with it installed.
What’s included
The light bar is the item covered here. Check the box for the connector, wiring and mounting tape before starting the installation.














