Overview
The Power Stop JBR738XPR is a rear slotted and cross-drilled brake rotor for the 2001–2003 Toyota Highlander and the 1999–2003 Lexus RX300. The JBR738XPR is made for the rear axle, uses cross-drilled holes together with slots, and arrives coated.
The drilled holes help keep rotors up to 180°F cooler, and the rounded slots sweep water, gas and dust away so the pad keeps a clear contact patch.
In Power Stop’s own wording, the JBR738XPR belongs to its Evolution line, where every rotor is mill balanced and the drilled and slotted face is meant to look good behind custom or factory wheels.
Cooling from the holes and clearing from the slots make this design practical for daily driving.
Key features
- Cross-drilled holes for cooling
- Rounded slots clear water, gas and dust
- Silver zinc plating resists rust
- G3000 grade casting
- Tru-Cast precision machining
- Beveled, precision-drilled holes
- Reduces brake fade
- Evolution rotor, mill balanced
- Run out within 0.0015, DTV tolerance within 0.005
- Direct-fit design
Rear axle maintenance
The rear axle on these Toyota and Lexus models carries less braking load than the front, but the rear rotor still works hard on long downhill runs and in stop-and-go traffic. Heat and gas from the pads need an exit path, and a drilled and slotted surface provides one while keeping the pad contact area clean.
Replace rear pads and rotors with matching parts so the friction surfaces wear evenly. Check the rear hub for play, look over the caliper and bracket bolts, and make sure the parking brake mechanism moves freely. Bedding in new pads gradually helps the pad transfer an even layer onto the new rotor face.
- Check the rear hub for play
- Inspect brake hoses for cracks
- Confirm parking brake adjustment after installation
Specifications
| Brand | Power Stop |
|---|---|
| Part number | JBR738XPR |
| UPC | 792088928429 |
| Type | Slotted and cross drilled |
| Position | Rear |
| Coating | Coated |
| Finish | Silver zinc plated |
| Material | G3000 grade casting |
| Machining | Tru-Cast precision machined, mill balanced |
| Tolerances | Run out within 0.0015; DTV within 0.005 |
| Drill holes | Beveled and precision drilled |
| Slots | Rounded slots sweep water, gas and dust |
| Cooling | The holes keep rotors up to 180°F cooler. |
| Line | Evolution |
| Fit | Direct fit |
Vehicle fitment
It fits the 2001–2003 Toyota Highlander (Base, Limited) and the 1999–2003 Lexus RX300 (Base). It is a rear rotor for the rear axle.
The JBR738XPR list stops at 2003 for the Highlander, so 2004–2007 models are outside it, and it is made for the rear axle. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Install the JBR738XPR on the rear axle only, and plan on fresh brake pads, since a drilled and slotted face works with pads that are in good condition.









