Overview
The 11-04-011-PC is a black powder coat aluminum rear logo plate for the 1976–1983 Jeep CJ5, the 1976–1986 Jeep CJ7 and the 1981–1985 Jeep Scrambler. It carries the Poison Spyder logo on the rear of the Jeep and is also called a tramp stamp.
The plate is CNC laser cut from high strength, lightweight aluminum. This version has a textured black powder coat finish. Supplied black truss-head pop-rivets secure the plate. It is designed to fit with Poison Spyder Crusher Corners, or with rear corner protection that ends at the body seam between the quarter panel and the tailgate.
Key features
- Textured black powder coat finish on aluminum
- Poison Spyder logo on the rear of the CJ and Scrambler
- CNC laser cut from high strength, lightweight aluminum plate
- Supplied black truss-head pop-rivets
- Designed to fit with Crusher Corners or similar rear armor
Before drilling the rear
Rear logo plates sit in a visible spot where the body meets the tailgate, so alignment matters. Mark the position with painter’s tape and step back to check level before any hole is made. Pop-rivets are permanent, so a test fit with the plate held in place is the simplest way to avoid a crooked install.
Aluminum plates flex more than steel and can crack around fastener holes if the mounting surface is uneven. Look at the body seam and any corner armor first, and make sure neither pushes against the plate once it is riveted. Over time, check the rivets during routine trail inspections, and replace any that feel loose or have worked out of the aluminum.
- Use painter’s tape to mark the plate position before drilling
- Check the body seam and corner armor for clearance
- Inspect rivets and plate edges after rough trail use
Specifications
| Brand | Poison Spyder Customs |
|---|---|
| Part number | 11-04-011-PC |
| UPC | 614901736083 |
| Material | High strength, lightweight aluminum plate |
| Finish | Black powder coat aluminum |
| Fasteners | Black truss-head pop-rivets, supplied |
| Location | Exterior, rear |
| Fitment type | Direct fit |
Vehicle fitment
It is a direct fit for the 1976–1983 Jeep CJ5 (Base, Golden Eagle, Laredo, Limited and Renegade), the 1976–1986 Jeep CJ7 (Base, Golden Eagle, Golden Hawk, Laredo, Limited and Renegade) and the 1981–1985 Jeep Scrambler (Base, Laredo, Renegade, SL and SR).
The list does not include the Wrangler YJ, TJ or JK. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
The plate installs with the supplied black truss-head pop-rivets. Check the body seam and any rear corner armor before drilling, since the plate is designed to end at that seam.
What’s included
The kit includes the black powder coat rear logo plate and the black truss-head pop-rivets.












