Overview
The Omix-ADA main bearing set, part number 17465.13, is a complete set of .010 oversize main bearings for the 2.5L engine. It is a direct OE replacement built to original Jeep specifications and fits several 1983–1990 Jeep models, including the Cherokee XJ and Wrangler YJ.
Main bearings support the crankshaft inside the engine, so this is an engine-internal part. The set is complete and carries a limited five year warranty from Omix-ADA.
Key features
- Complete set of main bearings
- .010 oversize for matching worn journals
- Direct OE replacement built to original Jeep specifications
- Designed for the 2.5L engine
- Carries a limited five year manufacturer warranty.
Before you start the job
Engine bearing work is a larger job than the part list suggests. The crankshaft must be measured against the journals, and oversize bearings only make sense when the journals are worn beyond standard size. A machine shop can check journal diameter, taper and out-of-round, which shows whether oversize bearings are the right choice.
Clearances and torque matter as much as the parts. Use fresh assembly lube on the bearing faces, tighten the caps to specification in the correct sequence, and confirm end play before closing up the engine. Bearings installed with the wrong clearance can fail quickly under load, so check each step.
Oil passages and the oil pump are worth inspecting while the bottom end is open. Flush the block, clean the oil galleries and replace the filter when you refill the engine.
- Measure journals before choosing oversize bearings
- Use fresh assembly lube on bearing surfaces
- Check clearances before final assembly
- Inspect the oil pump and galleries while open
Specifications
| Brand | Omix-Ada |
|---|---|
| Part number | 17465.13 |
| UPC | 804314146610 |
| Engine | 2.5L |
| Bearing size | .010 oversize |
| Set | Complete set |
| Fitment | Direct fit |
| Warranty | Limited five year manufacturer warranty |
Vehicle fitment
It fits 1984–1990 Jeep Cherokee (XJ), 1983 Jeep CJ5, 1983–1986 Jeep CJ7, 1986–1990 Jeep Comanche, 1983–1985 Jeep Scrambler, 1984–1987 Jeep Wagoneer (SJ) and 1987–1990 Jeep Wrangler (YJ), with trims for each.
It is designed for the 2.5L engine. Confirm your vehicle’s year, model and trim, and check that your engine is a 2.5L, before ordering.
Installation notes
Main bearings are internal engine parts, so installation involves engine disassembly and should be done by someone experienced with engine work. Work with the battery disconnected and the vehicle safely supported.
What’s included
A complete set of main bearings in .010 oversize.
Not included: Check the package contents against your installation before starting, including whether thrust washers are needed.









