Overview
The Crown Automotive throttle solenoid, part number CRO83502116, is a replacement solenoid for 1985–1993 Jeep models. It is for the Jeep Cherokee (XJ), CJ7, Comanche, Scrambler and Wrangler (YJ) in the model years covered below.
This solenoid falls in the carburetor idle stop solenoid category, under carburetors, intake manifolds and throttle bodies. It is for a 4 cylinder engine and is a direct fit. Crown Automotive supplies replacement Jeep parts, with over 8,000 part numbers including many factory-discontinued items.
Key features
- Direct fit
- Made for a 4 cylinder engine
- Crown Automotive part number CRO83502116
- Covers five Jeep models across the 1985–1993 model years listed
Signs of a failing solenoid
A throttle solenoid helps control engine idle, holding the throttle at a set position while the engine runs and, on some setups, keeping it from running on after the key is turned off. When it begins to fail, the usual symptoms are a rough or surging idle, a slow return to idle after you press the pedal, and an engine that keeps running briefly after shutdown. Inspect the connector and wiring for corrosion or loose pins before deciding the solenoid itself is at fault.
Vacuum leaks and worn throttle linkage can mimic solenoid trouble, so check hoses, the throttle plate and the linkage return spring as well. If the solenoid is replaced, confirm its travel and mounting position match the old unit, and make sure the plunger moves freely by hand before reinstalling. Replacing any gasket or seal at the mounting point helps prevent vacuum leaks after the change.
After installation, start the engine and check idle with the transmission in park or neutral, then cycle the key and confirm the engine stops cleanly. Recheck the idle after the first few drives, since small adjustments are common once the engine has warmed up.
Specifications
| Brand | Crown Automotive |
|---|---|
| Part number | CRO83502116 |
| Engine | 4 cylinder |
| Fitment type | Direct fit |
Vehicle fitment
Fits the 1985–1993 Jeep Cherokee (XJ) in base, Chief, Laredo, Pioneer and Sport trims; the 1985–1986 Jeep CJ7 in base, Laredo and Renegade trims; the 1986–1990 Jeep Comanche in several trims; the 1985 Jeep Scrambler in base, Laredo and Renegade trims; and the 1987–1990 Jeep Wrangler (YJ) in base, Islander, Laredo, S, Sahara and Sport trims.
Fit is limited to the models and years above. The Wrangler TJ and years outside those ranges are not covered, so check your year, model and trim before buying.
What’s included
Review the parts in the box against your installation before you begin.









