Overview
The Omix-ADA 16584.07 is a pinion thrust washer for the Dana 35 differential. Omix-ADA builds it as a direct OE replacement to the original Jeep specifications.
It fits the 1999–2001 Jeep Cherokee (XJ) in Classic, Limited, SE and Sport trims, the 1999–2002 Jeep Grand Cherokee (WJ) in Laredo, Limited, Overland and Sport trims, and the 1999–2002 Jeep Wrangler (TJ) in SE, Sahara, Sport and X trims.
Key features
- Direct OE replacement built to original specifications
- Pinion thrust washer for the Dana 35
- Fits three Jeep model ranges
Before you install
The pinion thrust washer sits behind the pinion gear inside the carrier and controls how far the pinion can move. Its thickness sets the pinion position and bearing preload, so the correct washer matters for quiet gear mesh and a long bearing life. Small changes in thickness can change how the gears feel under load.
Replacing the washer is usually part of a larger carrier job, especially when the pinion bearings or pinion gear have been removed. Check the old washer for scoring, heat marks or uneven wear, and inspect the thrust surfaces before fitting the new part. A sound washer that matches the original thickness helps the gears settle back into their original pattern.
- Note the original washer thickness before removing it
- Inspect the pinion gear and carrier for scoring
- Replace pinion bearings if the axle is already apart
- Check pinion preload with a torque wrench during setup
Specifications
| Brand | Omix-ADA |
|---|---|
| Part number | 16584.07 |
| UPC | 804314004125 |
| Axle | Dana 35 |
| Component | Pinion thrust washer |
Vehicle fitment
It fits the 1999–2001 Jeep Cherokee (XJ), 1999–2002 Jeep Grand Cherokee (WJ) and 1999–2002 Jeep Wrangler (TJ), in the trims named above.
The Wrangler (TJ) is listed only for 1999–2002, so earlier TJ years are not included.
Confirm your vehicle’s year, model and trim before ordering.
What’s included
One pinion thrust washer, Omix-ADA part number 16584.07.
