Overview
The 16523.43 is the inner mid shaft of the front axle for the 2002-2007 Jeep Liberty (KJ), with 27 splines.
It is a direct OE replacement built to original specifications, with a limited five year warranty. The axle type is Dana 30A KJ, a Dana-built front axle.
Check the shaft’s spline count and axle type against your vehicle’s axle before installing.
Key features
- Dana 30 front axle shaft
- Inner mid shaft location
- 27 splines
- Axle type Dana 30A KJ
- Front inner position
- Direct OE replacement built to original specifications
- Limited five year warranty
Axle shaft wear signs
An axle shaft carries drive torque from the differential to the wheel hub, and its joints and splines take a lot of stress over time. Common signs of wear include clicking on tight turns, vibration under acceleration and grease leaking from a joint boot. Any of these signs should be checked before the shaft is put back into service.
Spline wear can show as a loose fit at the hub or differential end. When a shaft is replaced, the matching hub and differential seal surfaces should be checked for wear too, since a worn surface can cause a new part to vibrate. Keep the work area clean, because dirt entering the joint or spline can shorten service life.
- Check the spline fit at both ends
- Inspect the boot and joint for grease leaks
- Torque hub fasteners to the vehicle’s specification
Specifications
| Brand | Omix-Ada |
|---|---|
| Part number | 16523.43 |
| UPC | 804314134143 |
| Product type | Axle shaft |
| Axle type | Dana 30A KJ |
| Axle manufacturer | Dana |
| Axle location | Front |
| Axle shaft location | Inner mid shaft |
| Position | Front inner |
| Axle spline | 27 splines |
| Warranty stated in source | Limited five year warranty |
| Fit type | Direct fit |
Vehicle fitment
The stored manufacturer fitment list for the Omix-ADA 16523.43 covers the 2002-2007 Jeep Liberty (KJ) in 65th Anniversary Edition, Limited, Renegade, Rocky Mountain Edition and Sport trims.
It fits the 2002-2007 Jeep Liberty KJ. Confirm which side of the front axle the shaft installs on, and check fit against your year, model and trim before ordering.
Installation notes
Suspension components affect steering, braking and handling, so professional installation is recommended. Follow the torque specifications and procedure for your vehicle.
Re-check all hardware after the first miles of driving, and have the alignment checked after any suspension work. Changes in ride height can affect brake lines, driveline angles and headlight aim, and local regulations on vehicle lift may apply.
Axle shafts are driveline parts. Support the vehicle on jack stands, replace seals or related parts as needed, and refill fluids to the correct level.
Before installing, compare the part number on the package with 16523.43 and check that all parts are present. Work on level ground, wear eye protection, and keep the vehicle’s instructions nearby.
What’s included
Check the package contents against your installation before starting, as seals, fluids and hardware may be needed.
