Overview
It is a driver side replacement rear quarter panel with dog leg for the 1984–2001 Jeep Cherokee (XJ) in 4-door form.
The panel is made from high gauge steel with an OEM Electro-Deposit primer (EDP) finish. Key Parts says its replacement panels are designed for exact OEM fit and wider coverage than competitor panels, and the dog leg section is part of the panel design.
Key features
- Driver side rear quarter panel
- Dog leg section included.
- Made for 4-door models
- High gauge steel with OEM Electro-Deposit primer
Before a quarter panel repair
A rear quarter panel covers the wheel arch and the side of the body behind the rear door, and it carries structural load where it joins the floor and roof. Rust tends to start in hidden areas such as the lower edge, the wheel well lip and seams, so the surrounding metal should be checked before any new panel goes on. A body shop can cut out the damaged section, clean the flange and test-fit the panel against the door gap and tail light opening.
Quarter panels are often replaced along with the rocker, wheel arch lip and sealers, so budget for those parts during the same repair. After welding, the seam area needs seam sealer, anti-corrosion coating and touch-up primer to protect bare steel.
- Check the floor pan and rocker for rust before fitting
- Confirm door gap and tail light alignment with the new panel
- Plan for seam sealer and anti-corrosion coating
- Keep the dog leg area free of trapped moisture
Specifications
| Brand | Key Parts |
|---|---|
| Part number | 0482-131L |
| UPC | 70000700314 |
| Position | Driver side |
| Body style | 4-door models |
| Material | High gauge steel |
| Finish | OEM Electro-Deposit primer (EDP) |
| Fit type | Direct fit |
Vehicle fitment
It fits the 1984–2001 Jeep Cherokee (XJ) in Base, Briarwood, Chief, Classic, Country, Laredo, Limited, Pioneer, SE and Sport trims.
It covers the Cherokee XJ only. Grand Cherokee, Liberty and Wrangler models are not covered, and two-door bodies are not included. Match your Cherokee’s year, model and trim to this fitment before ordering.
Installation notes
Quarter panels are normally welded to the body, so installation is body shop work rather than a bolt-on job.
What’s included
One driver side rear quarter panel with dog leg, part number 0482-131L.









