Overview
The Dana Spicer 708014 is a Dana 60 Trac-Loc limited slip differential carrier case, supplied empty. It suits a gear change to a carrier with a different ring gear landing, where replacing spider gears is not needed.
Dana Spicer gives the axle location as both Rear and Front, with the differential type as limited slip case only. It is marked universal fit, so confirm which axle position your housing is before fitting.
Key features
- Empty limited slip carrier case
- Dana 60 axle type
- Ring gear landing change option
- Dana Spicer O.E. case
Gear change and setup
Changing the ring gear landing is a common reason to replace a carrier case, because the new ring gear must mount squarely to the flange. Before buying a ring gear, check its bolt pattern and back-face dimension against the housing. Pinion depth and ring gear backlash are then set with shims, and getting this right matters more than any other step in the job.
Trac-Loc units rely on clutch packs, so inspect the discs, plates and spring pack when the case is open. A setup that puts too much load on one side can accelerate clutch wear. Reusing old bearings with a new gear set is generally avoided, since worn bearings cannot hold the preload needed for a quiet, lasting mesh.
Specifications
| Brand | Dana Spicer |
|---|---|
| Part number | 708014 |
| Axle type | Dana 60 |
| Axle location | Rear and front |
| Axle spline | Empty case |
| Differential type | Limited slip differential case only |
Vehicle fitment
This carrier case is not vehicle-specific. It is marked universal fit for Dana 60 axles, with location given as rear and front. Neither vehicle years nor models are given, so confirm the axle position before fitting.
Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Gear mesh and bearing preload are set after the new ring gear is fitted to the empty case, so use a professional for that step.
What’s included
The empty limited slip carrier case only.
Not included: ring gear, pinion and bearings.









