Overview
The 76136-5X is a 4.30 ratio ring and pinion for the Dana 50 front axle. Its gears follow the factory Dana gear design.
A 4.30 ratio gives less torque multiplication at the wheels than a 4.56 or 5.38 set. Confirm the front Dana 50 axle and housing before ordering.
Key features
- 4.30 ratio front ring and pinion
- Dana 50 front axle type
- Matches factory Dana gear design.
- Popular performance and replacement ratio
Front axle considerations
The front axle carries steering loads as well as drive torque, so a ring and pinion change affects more than straight-line speed. Gear mesh, carrier bearing preload and pinion depth all influence noise and tooth life. On many four-wheel-drive setups, front and rear ratios are matched so the transfer case and driveline work together. Check the transfer case setup before deciding on a new set.
Worn front gears often show up as a whine that changes with load, or a rough feel when the front axle engages. Inspect the axle bearings, the axle seals and the pinion seal before reassembly. A driveline shop can check the gear pattern with marking compound, which shows whether the set is seating correctly and is worth doing before the axle goes back into service.
Specifications
| Brand | Dana Spicer |
|---|---|
| Part number | 76136-5X |
| Gear ratio | 4.30 |
| Axle location | Front |
| Axle type | Dana 50 |
| Popular axle manufacturer | Dana |
Vehicle fitment
Confirm the axle type and gear ratio match your housing before ordering.
The Dana 50 is a separate axle from the Dana 60 and Dana 70, so confirm the axle name on the housing. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Pinion depth, backlash and bearing preload for this 4.30 Dana 50 gear set should be set by a driveline shop, followed by a break-in period.
What’s included
A 4.30 ring and pinion set for the Dana 50.












