Overview
The Dana Spicer 2020927 is a 4.30 ratio Value Line ring and pinion for the Dana 50 front axle. It comes from the aftermarket Value Line range and is made for automotive and commercial use.
The set is a front ring and pinion for the Dana 50 axle type, and a 4.30 ratio gives less torque multiplication at the wheels than a 4.56 or 5.38 set. Dana Spicer says these gears are engineered for the vehicle they are fitted to.
Key features
- 4.30 ratio front ring and pinion
- Dana 50 front axle type
- Dana Spicer Value Line aftermarket range
- All-makes coverage described by Dana Spicer
- Popular Dana axle manufacturer
Choosing an aftermarket gear set
Aftermarket gear sets give an option to the factory ring and pinion when a different ratio is wanted. A 4.30 set is a moderate step in torque multiplication compared with higher numerical ratios. Comparing the gear ratio to tire size and intended use helps narrow the choice before ordering.
Front axle gears wear with steering loads and axle articulation, so the pinion bearing and carrier bearings deserve attention during installation. Check the pinion seal, axle shafts and ring gear teeth when the cover is off. Replace any worn parts before final setup, since fresh gears can be damaged by worn support parts.
- Confirm the axle name on the housing
- Check the carrier bearing condition
- Keep the gear oil clean during break-in
Specifications
| Brand | Dana Spicer |
|---|---|
| Part number | 2020927 |
| Gear ratio | 4.30 |
| Axle location | Front |
| Axle type | Dana 50 |
| Popular axle manufacturer | Dana |
| Range | Value Line |
Vehicle fitment
The set is made for the Dana 50 front axle type. Match the axle type and gear ratio to your housing before ordering.
Dana 50 gears are a different axle from the Dana 60 and Dana 30 layouts, so confirm the axle name on the housing before ordering. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Pinion depth, backlash and bearing preload need a driveline shop for this Dana 50 gear set, followed by a break-in period on the 4.30 ratio.
What’s included
A 4.30 ring and pinion set for the Dana 50. Check the package contents against your installation before starting.













