Overview
The Dana Spicer 2019749 is a differential ring and pinion set for the Dana 44 axle. Dana Spicer describes its ring and pinion gears as genuine Spicer gearing designed and tested to meet original equipment specifications.
Dana says all Spicer ring and pinion gears are designed and tested to meet original equipment specifications, using premium heat treatment, optimal tooth profiles and high-grade steel. Dana also says its ring and pinion sets are the same gears that came in a Dana axle from the factory.
Match this set to your axle by checking the gear markings on your current set and the Dana 44 axle name.
Read the gear markings on your current set and confirm the tooth count, ratio and position before ordering.
Key features
- Genuine Spicer ring and pinion gearing
- Made for the Dana 44 axle
- Designed and tested to meet original equipment specifications.
- Premium heat treatment, optimal tooth profiles and high-grade steel.
- It comes in popular performance and replacement ratios.
Gear sets and pinion setup
A ring and pinion set is only half of a gear swap. The pinion depth, backlash and bearing preload must be set so the teeth make even contact, and a poor setup causes noise and early wear no matter how good the gears are. Most owners rely on a shop with setup tools for this step.
When you buy a new set, look at the carrier bearings, pinion seal and crush sleeve as well. Old bearings with play can shorten the life of new gears, and a worn seal often leaks soon after the gears go in. Use gear oil of the specified type and keep the fill level correct.
- Plan a break-in period with gentle driving.
- Re-check backlash after the first few drives.
- Mark the gear set position before you start.
Specifications
| Brand | Dana Spicer |
|---|---|
| Part number | 2019749 |
| UPC | 23913465575 |
| Product line | Spicer ring and pinion |
| Axle | Dana 44 |
| Category | Axle Parts > Ring and Pinions |
Not stated by the manufacturer: the gear ratio, tooth counts, whether it is a front or rear set, and what installation hardware (if any) is included.
Vehicle fitment
It is made for the Dana 44 axle, and a Dana 44 ring and pinion only suits a Dana 44 axle with a compatible housing. Confirm the axle, its ratio and its position rather than relying on a vehicle name.
Not stated: any vehicle year, make or model, and no other Dana axle size is covered. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Setting up a ring and pinion means adjusting pinion depth and backlash and reading the tooth contact pattern; the new gears also need a break-in period. Many owners leave this to a shop.







