Overview
The Crown Automotive 8997109CJ8 is a black fender flare kit for the 1981 to 1985 Jeep Scrambler. The kit includes front and rear flares along with hardware. The black finish can be painted if a different color is wanted.
The rear flare install requires a modification to the vehicle, so the rear pieces are not a bolt-on fit. Width and tire coverage are stock rather than a set measurement. Fitment covers the 1981 to 1985 Scrambler Base, Laredo, Renegade, SL and SR versions.
Key features
- Black finish, paintable
- Front and rear flares in one kit
- Includes hardware
- Rear install requires modification
- Width and coverage are stock
Rear clearance on the Scrambler
The rear flare on an older Scrambler sits close to the body and the rear tire, so modification planning is the step that decides the install. Before cutting or drilling, mark the intended mounting points with masking tape and check that the flare clears the tire at full travel. Measure from the wheel opening to the flare edge on both sides, since small differences can change the fit.
Front flares are usually the easier job, but they still need clearance checks against the steering components and the inner fender. Keep the hardware sorted by position, and tighten fasteners in stages so the flare edge sits evenly. If the Scrambler is used off-road, recheck every fastener after rough trail runs, because vibration can loosen mounts over time.
Specifications
| Brand | Crown Automotive |
|---|---|
| Part number | 8997109CJ8 |
| UPC | 70000646611 |
| Position | Front and rear |
| Width and tire coverage | Stock |
| Quantity | Set of 4 |
| Fit type | Direct fit |
| Finish | Black, paintable |
| Model years | 1981 to 1985 Jeep Scrambler |
Vehicle fitment
It fits the 1981 to 1985 Jeep Scrambler in the Base, Laredo, Renegade, SL and SR versions. Scrambler model years outside that range are not covered.
Confirm your vehicle’s year, model and trim before ordering.
Installation notes
The rear flare install requires a modification to the vehicle. Check the rear clearance and mounting points before cutting or drilling anything.
What’s included
A set of four flares with hardware, in black.









