Overview
The Crown Automotive 52070427AB is a steel and rubber rear left axle seal for Chrysler 8.25 inch rear axles. It presses into the axle tube.
It is for the rear left position and fits the Chrysler 8.25 inch rear axle.
Key features
- Steel and rubber construction
- Presses in
- Rear left position
- Chrysler 8.25 inch rear axle seal
- Crown Automotive part number 52070427AB
Installing a press-in seal
A press-in axle seal sits in the axle tube and seals the bearing area against the lubricant inside. Fitting it square matters, because a cocked seal can leak within a short time or push the lip out of position. Clean the bore thoroughly, check for burrs or corrosion, and use a proper seal driver or a suitable tool rather than a hammer.
Before fitting, inspect the axle shaft where the seal lip rides, since a grooved or rusted surface can damage the new lip. Light lubricant on the lip helps it slide into place. After the job, check for leaks around the seal and the axle tube and top up the lubricant as needed.
- Check the bearing for play or roughness
- Clean the axle tube bore before pressing
- Replace the gasket or sealant at the cover if disturbed
Specifications
| Brand | Crown Automotive |
|---|---|
| Part number | 52070427AB |
| UPC | 848399038859 |
| Position | Rear left |
| Axle | Chrysler 8.25 inch rear |
| Construction | Steel and rubber |
Vehicle fitment
It fits the 2002–2009 Dodge Dakota, the 2000–2003 Dodge Durango, the 2007–2008 Dodge Nitro, the 2002–2006 Dodge Ram 1500 and 2500, the 2002 Dodge Ram 3500, the 1999–2001 Jeep Cherokee (XJ) and the 2002–2008 Jeep Liberty (KJ), in the trims covered for each.
Other Dodge and Jeep years and models are not on this list. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Because the seal presses in, it is fitted into the axle tube rather than bolted on. Match the rear left position before fitting.
What’s included
One rear left axle seal.








