Overview
The Omix-Ada 16535.10 is an inner axle oil seal for Dana 35 rear axles, sold individually. It sits in the rear inner position and fits 1988–1989 Jeep Wrangler (YJ) models.
It is a direct OE replacement, built to original specifications.
Key features
- Inner oil seal for Dana 35 rear axles
- Rear inner position
- Sold individually
- Direct OE replacement built to original specifications
Before you replace the seal
Inner axle seals keep lubricant inside the axle housing and keep water and grit out where the axle shaft passes through. Because the seal sits inside the housing, replacing it means draining the lubricant and opening the axle, so plan on fresh gear oil and a clean work area.
Before fitting a new seal, inspect the bearing surfaces and the axle shaft where the seal rides. A grooved or rough surface can wear a new seal quickly, and it is a good time to check the gasket and cover for leaks too.
- Clean the housing bore before installing
- Use fresh gear oil at the correct level
- Inspect the axle shaft for grooves or pitting
Specifications
| Brand | Omix-Ada |
|---|---|
| Part number | OAI16535.10 |
| Position | Rear inner |
| Axle | Dana 35 |
| Sold | Individually |
Vehicle fitment
It fits the 1988–1989 Jeep Wrangler (YJ) in the Base, Islander, Laredo, S, Sahara and Sport trims.
Wrangler YJ years outside 1988–1989 and other Jeep models are not on this list. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
As an inner seal, it sits inside the rear axle housing, so the axle has to be opened to replace it.
What’s included
One inner oil seal, sold individually.









