Overview
The Body Armor 4×4 JK Wrangler Steel Plate Rear Base Bumper, part JK-2961, is a textured black steel rear bumper for the 2007-2018 Jeep Wrangler JK. It is built from 3/16 inch steel plate with gusseted mounting plates. The JK chassis code covers the 2007 to 2018 model years.
Key features
- Sculpted design kept compact to the body for better departure angles
- 3/16 inch steel plate for strength
- Machined pivot shaft for the swing arm 5293
- Reinforced gusseted mounting plates
- Double shackles for recovery points
- Notched to retain the factory trailer hitch
Choosing a JK rear bumper
A rear bumper on a JK does more than protect the tailgate area. It sets the approach and departure geometry at the back of the vehicle, carries recovery loads, and must clear the rear body and any tow equipment you run. A steel bumper with gusseted mounting plates puts its load into the frame rather than the sheet metal around it, which matters most when you winch or recover from a rut.
When choosing among rear bumpers, look at how the mounts tie into the chassis, whether the notch or cutout suits your hitch setup, and how the shackle points are positioned for your recovery gear. Compare the tire carrier plan too, since a carrier adds weight and changes how the bumper sits under load. Check that any spare tire or light mounts still clear the bumper after installation.
- Match the bumper to your JK year and trim before ordering
- Confirm hitch and recovery gear needs first
- Check that rear clearances remain after mounting
Specifications
| Brand | Body Armor 4×4 |
|---|---|
| Part number | JK-2961 |
| UPC | 859909002352 |
| Material | 3/16 inch steel plate |
| Finish | Textured black powder coat |
| Body style | 2 and 4-door models |
| Recovery | Double shackles |
| D-ring mount | Included |
Vehicle fitment
It fits the 2007-2018 Jeep Wrangler JK. It does not fit the later JL generation of the Wrangler. Confirm fit for your vehicle’s year, model and trim before ordering.
Confirm your vehicle’s year, model and trim before ordering.
Installation notes
It is a bolt-on installation. The notch in the bumper keeps the factory trailer hitch in use.
What’s included
One rear base bumper in textured black, with its double shackles and D-ring mount.
Not included: the swing arm 5293, which is referenced for the pivot shaft.












