Overview
The Desert Series rear bumper is a powder-coated steel rear bumper for the 2016–2021 Toyota Tacoma. It is made in the USA and finished in Mini-Tex deep black powder coat over two coats of zinc-based primer.
The bumper combines a tubular frame with lighter sheet metal panels, which Body Armor 4×4 says allows a strong rear bumper at a lower weight. Its bottom edge tapers up from the center toward the sides for ground clearance.
The step deck on top has dimple-die embossed holes for strength, and the surface is non-slip. The bumper includes provisions for backup sensors, the OEM license plate lights and a lockable spare tire access port.
The bumper is designed to retain the OEM receiver hitch, so the factory hitch stays in place.
Key features
- Tubular frame with lighter sheet metal panels
- Non-slip step deck with embossed holes for strength
- Tapered bottom edge for ground clearance
- Provisions for backup sensors, OEM license plate lights and a lockable spare tire access port
- Mini-Tex deep black powder coat over two coats of zinc-based primer
Tow and hitch planning
The factory receiver hitch stays in place with this bumper, so towing setup depends on the original hitch rating and wiring. Before towing, check the hitch’s rated capacity against the trailer and the truck’s own limits. A bumper adds weight at the rear, which affects tongue weight and rear tire load. Keep the hitch pin and clip in good condition and inspect the receiver for cracks or wear after heavy loads.
Sensors and license plate lights are often rewired when a rear bumper goes on, so test them after mounting. Backup sensors need clear, unobstructed positioning to read correctly. A spare tire access port that locks is useful, but keep its key separate from the hitch equipment. Periodic checks of the powder coat near the hitch receiver help catch scratches before they turn into rust.
- Confirm hitch rating before towing
- Test backup sensors after mounting
- Check hitch pin and clip regularly
Specifications
| Brand | Body Armor 4×4 |
|---|---|
| Part number | TC-2962 |
| Position | Rear |
| Construction | Tubular frame with sheet metal panels |
| Finish | Mini-Tex deep black powder coat over two coats of zinc-based primer |
| Receiver hitch | Not included; the OEM hitch is retained |
| D-ring mount | Not included |
| Tire carrier | No |
| Made in | USA |
Vehicle fitment
The fitment covers the 2016–2021 Toyota Tacoma.
The list covers only 2016–2021 Tacoma models, so earlier and later generations and other Toyota models are not included. Confirm your vehicle’s year, model and trim before ordering.
What’s included
The backup sensor provisions, OEM license plate light provisions and lockable spare tire access port are built in. Not included: a receiver hitch, since the OEM hitch is retained, and a D-ring mount.









