Overview
The Baer Brakes 6801303LP is a left side port Remaster master cylinder with a 1.125-inch (1-1/8 inch) bore, a 4-bolt Mopar firewall mounting flange and a gray anodized body. It is a one-piece, fully machined 6061 T6 billet aluminum unit intended for the many early Mopar applications that use this flange.
Its gray body is paired with black anodized caps and lid. Two knurled screw-on caps make filling easier. Inverted flare fittings use the removable brass seats, while banjo or straight fittings can also be run from the 3/8-24 outlet ports. It is compatible with most long and short boosters, with an included bullet, or with manual brake applications. Optional proportioning valves are available.
Key features
- Fully machined 6061 T6 billet aluminum construction
- 4-bolt Mopar firewall mounting bracket
- Left side outlet ports
- Two 3/8-24 outlet ports
- Machined, knurled screw-on caps for filling without spillage
- Dual integral reservoirs, 7oz per reservoir
- Gray body with black anodized caps and lid
Left-port routing and clearance
Left side outlets change how the brake lines reach the wheels, so plan the route before the master cylinder is bolted in place. Keep the lines clear of the pedal linkage, the brake booster or pushrod area, and any steering or exhaust components that could rub or heat them. Gentle, consistent bends are better than tight kinks, which can restrict flow and crack the tube.
Once the lines are routed, check that each fitting seats squarely and that nothing pulls on the outlet ports. Brake lines that are stretched or twisted during the job can loosen over time, so support them with clips and recheck clearance after the first few drives.
- Route lines away from heat sources
- Avoid kinks and sharp bends
- Support lines with clips at each run
- Recheck clearance after the first drives
Specifications
| Brand | Baer Brakes |
|---|---|
| Part number | 6801303LP |
| UPC | 844165052203 |
| Series | ReMaster |
| Bore size | 1.125 inch (1-1/8 inch) |
| Flange type | 4 Bolt Mopar |
| Body material | 6061 T6 billet aluminum |
| Body finish | Gray anodized |
| Caps and lid finish | Black anodized |
| Port exit | Left side |
| Outlet port quantity | 2 |
| Outlet port size | 3/8-24 inch |
| Outlet port fittings | Banjo w/o brass seat, 3/16 inch inverted flare and tube nuts w/ brass seat |
| Removable seats | Yes |
| Reservoir type | Dual, integral |
| Reservoir size | 7oz per reservoir; fill to 75 percent or 5.25oz per reservoir |
| Stroke | 1.3 |
| Area | 0.97 |
| Volume ratio | 0.0840277777777778 |
| Country of origin | USA |
Vehicle fitment
It is built for early Mopar brake systems that use this 4-bolt firewall flange. Verify your vehicle’s year, model and trim before placing an order.
Compare the bore and mounting flange with the unit you are replacing before installing.
Installation notes
Brass seats and tube nuts are included for the inverted flare outlets, so banjo fittings can be used without them. Bleeder screws, bleeder hoses, mounting hardware and a sensor are not included, so have them on hand before the job begins.
What’s included
One Remaster master cylinder assembly with a master cylinder cap, two brass seats and two tube nuts. Fittings are included.
Not included: bleeder screws, bleeder hoses, brake booster, brake pressure switch(es), gasket or seal, mounting hardware and sensor.













