Overview
The Baer Brakes Remaster 6801300LP is a 1 inch bore master cylinder with left side outlet ports and a 4-bolt mounting flange for early Mopar applications. It is a small, compact, 1-piece billet unit that works with most long and short boosters or manual brake setups. Confirm the bore, flange and port layout against your current master cylinder before installing.
The body is machined from 6061 T6 billet aluminum and finished in gray anodize. Its billet top is held by 6 allen screws, and two large knurled screw-on caps make filling the dual reservoirs easier without spillage. Optional proportioning valves are also available for this cylinder.
Key features
- 4-bolt Mopar firewall mounting bracket
- Fully machined 6061 T6 billet aluminum construction
- Outlet ports accept inverted flare fittings with removable seats, banjo fittings or straight fittings
- Left side ports
- Machined, knurled screw-on caps for filling without spillage
- Anodized body with laser-etched logos
Things to check
Fluid reservoirs on a dual master cylinder keep the two brake circuits separate, so a fault in one half leaves the other working. When the cylinder is replaced, check the reservoir caps for a snug seal and make sure the fill level is correct before the first start-up.
Seals inside a master cylinder wear over time. Signs include a soft or sinking pedal, fluid seeping from the body, or a fluid level that drops without a visible leak at the wheels. Inspect the outlet port threads and fittings at the same time, because a worn seat can leak even when the cylinder itself is sound.
Bleeding the circuit after the swap removes trapped air, which otherwise makes the pedal feel spongy. Bleeding is best done with a helper and fresh fluid, working from the farthest wheel toward the closest. Recheck the pedal with the engine off and on before the car leaves the driveway.
Specifications
| Brand | Baer Brakes |
|---|---|
| Part number | 6801300LP |
| UPC | 844165052142 |
| Series | Remaster |
| Country of origin | USA |
| Sold as | Each |
| Body material | 6061 T6 billet aluminum |
| Body finish | Anodized, gray |
| Caps and lid finish | Anodized, black |
| Bore size | 1 inch |
| Stroke | 1.1 |
| Flange type | 4-bolt Mopar |
| Outlet port quantity | 2 |
| Outlet port size | 3/8-24 inch |
| Outlet port exit | Left side |
| Outlet fittings | Banjo without brass seat; 3/16 inch inverted flare and tube nuts with brass seat |
| Removable seats | Yes |
| Reservoir | Dual, integral, 6061 T6 billet aluminum |
| Reservoir size | 7oz per reservoir; fill to 75 percent or 5.25oz per reservoir |
| Included | 1 master cylinder assembly, 2 brass seats, 2 tube nuts |
Vehicle fitment
The 6801300LP suits many early Mopar applications with a 4-bolt flange. Confirm its bore, flange and port layout against your vehicle before ordering.
Confirm your vehicle’s year, model and trim before ordering.
Installation notes
The 4-bolt flange mounts to a firewall bracket, but mounting hardware is not included, so firewall bolts must be sourced separately. The bleeder screw, bleeder hoses and brake pressure switch are also not included. Bleed the brake system and check every fitting for leaks before driving.
What’s included
One master cylinder assembly with cap, 2 brass seats and 2 tube nuts.
Not included: mounting hardware, bleeder screw, bleeder hoses, brake booster, brake pressure switch, gasket or seal, sensor.













