Overview
Gray anodized ReMaster master cylinder with right side ports and a 1.125 inch (1-1/8) bore. It is made for the 1999-2004 Ford Mustang Cobra with hydroboost, and its two bolt flange is sized for the SN95 hydroboost firewall bracket.
The body is 6061 T6 billet aluminum with a gray color and anodized finish, while the caps and lid are black with an anodized finish. The dual integral reservoir is sized at 7oz per reservoir, and the outlet ports take inverted flare fittings with removable brass seats or banjo style fittings.
Key features
- Gray body with black anodized caps and lid
- Right side port exit with two 3/8-24 outlets
- Two-bolt flange for the 1999-04 SN95 Mustang hydroboost firewall bracket
- Fully machined 6061 T6 billet aluminum construction
- Removable brass seats for inverted flare outlets; banjo style fittings also supported
Caring for anodized aluminum
Anodizing forms a hard oxide layer on the aluminum surface, which helps the finish resist scratches and surface wear. Clean the cylinder with mild soap and water and a soft cloth. Avoid abrasive pads or harsh solvents, which can dull the color over time. Brake fluid spilled on the finish should be wiped away promptly, since it can damage paint and some coatings nearby.
Gray and black finishes show scratches more easily than polished metal, so take care when routing lines and tools near the cylinder during installation. Keep the caps screwed on securely to keep dirt and moisture out of the reservoirs. Inspect the finish during routine service and look for any seepage around the outlet fittings.
- Clean with mild soap and a soft cloth
- Wipe brake fluid spills promptly
- Keep caps tight to keep out dirt and moisture
Specifications
| Brand | Baer Brakes |
|---|---|
| Part number | 6801329RP |
| UPC | 844165054276 |
| Series | ReMaster |
| Bore size | 1.125 inch (1-1/8) |
| Material | 6061 T6 billet aluminum |
| Body color | Gray |
| Body finish | Anodized |
| Caps color | Black |
| Caps finish | Anodized |
| Lid color | Black |
| Lid finish | Anodized |
| Port exit | Right side |
| Outlet ports | 2 at 3/8-24 |
| Outlet fittings | Banjo without brass seat; 3/16 inch inverted flare with tube nuts and brass seat |
| Reservoir | Dual integral; 7oz per reservoir, fill to 75 percent or 5.25oz per reservoir |
| Flange | 2 bolt, 1999-04 SN95 Mustang hydroboost specific |
| Stroke | 1.3 |
| Country of origin | USA |
Vehicle fitment
The cylinder is made for the 1999-2004 Ford Mustang Cobra hydroboost system, with a flange built for the 1999-04 SN95 hydroboost bracket. Confirm the model year and hydroboost setup before ordering.
Other Mustang model years and brake setups without that SN95 bracket fall outside this flange design. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Confirm the SN95 hydroboost bracket is present before fitting, since the cylinder bolts to it rather than to a standard firewall. Choose the fitting type for each outlet: banjo takes no seat, while inverted flare uses the brass seats and tube nuts provided. Fill the reservoirs to the 75 percent level stated in the specifications.
What’s included
One Remaster master cylinder assembly with reservoir, cap, two brass seats and two tube nuts.
Not included: the booster, flange hardware, bleeder screw, bleeder hoses and brake pressure switch, which must be obtained separately.













