Overview
The Baer Brakes 6801328LP is a left port Remaster master cylinder for the 1999 to 2004 Ford Mustang SN95 with hydroboost brakes. It has a 1-1/8 inch (1.125) bore and uses a two-bolt firewall flange sized for the SN95 hydroboost bracket. The body is machined from 6061 T6 billet aluminum and finished in black anodized.
Because the outlet ports exit on the left, this version suits installations where the brake lines run out the left side of the cylinder. The compact one-piece body carries a dual integral reservoir and two knurled screw-on caps for filling. The outlets take either inverted flare fittings with removable brass seats, or banjo and straight fittings.
Key features
- Fully machined 6061 T6 billet aluminum body
- Two-bolt flange for the 1999-04 SN95 Mustang hydroboost firewall bracket
- Left side ports with 3/8-24 outlet threads
- Removable brass seats for 3/16 inch inverted flare, banjo or straight outlets
- Two knurled screw-on caps for spill-free filling
- Black anodized finish with laser-etched logos
Bleeding and line routing
Left port cylinders place the outlets on the opposite side from right port units, so the brake line routing has to be planned before anything is tightened. Lay out the hard lines and flexible hoses with enough slack to avoid rubbing on suspension, steering and body parts. A line that is pulled tight at one end will stress the fitting and can crack over time.
Bleeding the system removes air that would otherwise make the pedal feel soft. Work from the wheel farthest from the master cylinder toward the nearest, keep the reservoir topped up so air is not drawn back in, and discard fluid that has been drained. A final pedal check and leak inspection should follow before the car is driven.
- Keep the reservoir above the minimum line during bleeding
- Re-check fittings after the first short drive
Specifications
| Brand | Baer Brakes |
|---|---|
| Part number | 6801328LP |
| UPC | 844165054245 |
| Series | Remaster |
| Body material | 6061 T6 billet aluminum |
| Finish | Black anodized body, caps and lid |
| Bore size | 1.125 inch (1-1/8 inch) |
| Outlet port size | 3/8-24 inch, 2 outlet ports |
| Port exit | Left side |
| Flange type | 2 bolt, 1999-04 SN95 Mustang hydroboost specific |
| Reservoir | Dual, integral, 6061 T6 billet aluminum |
| Reservoir size | 7oz per reservoir; fill to 75 percent or 5.25oz per reservoir |
| Stroke | 1.3 |
| Removable seats | Yes, 2 brass seats included |
| Sold as | Each |
| Country of origin | USA |
Vehicle fitment
The cylinder is intended for 1999-04 SN95 Mustangs that have hydroboost brakes.
It does not cover Mustangs with non-hydroboost brakes, because the flange is specific to the hydroboost bracket. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Plan the line routing around the left side outlets before tightening any tube nuts. The seats are removable, so the inverted flare or banjo connection can be chosen at assembly. Mounting hardware is not included, and the bleeding and leak check should be completed before the vehicle is driven.
What’s included
One master cylinder assembly with reservoir and cap, two brass seats and two tube nuts.
Not included: brake booster, mounting hardware, bleeder screw, bleeder hoses, brake pressure switch, gasket or seal, and sensor.













