Overview
The Poison Spyder Stock Crusher Corners in bare steel (part number 14-04-010) are corner guards cut from 3/16 inch plate steel. They protect the body corners of a Jeep from rock damage. Each corner is laser cut from high strength plate and carefully roll formed to match the body lines.
The stock version includes the factory wheel and fuel filler opening and mounting holes for the factory equipment, including the factory flares, tail light and license plate frame. The corners ship as bare steel, with no coating applied.
Key features
- 3/16 inch plate steel, laser cut and roll formed
- Opening for the factory wheel and fuel filler
- Mounting holes for the factory flares, tail light and license plate frame
- Countersunk bolt holes for a flat surface
- Supplied stainless steel flat head cap screws
Protecting corners on the trail
Body corners take hits from rocks, stumps and tight trail edges, so a corner guard is a practical addition for a Jeep that sees rough terrain. Bare steel protects well against impact, but it needs attention to resist rust. Once the corners are cut and drilled, the bare edges should be cleaned and coated so moisture does not start corrosion at the holes.
Before installation, plan the layout around the wheel opening, fuel filler, flares and tail light. Test the fit with the corners held in place before marking any holes. After the first few trail sessions, check the bolts and the paint or coating around the edges, since rock contact can chip the finish first.
- Clean and degrease the steel before coating
- Mark and test-fit before drilling
- Touch up chips along the bolt holes
- Check the bolts after the first trail runs
Specifications
| Brand | Poison Spyder Customs |
|---|---|
| Part number | 14-04-010 |
| UPC | 614901724981 |
| Type | Body corner guard, stock style |
| Corner type | Full |
| Material | 3/16 inch plate steel |
| Finish | Bare steel |
| Hardware | Stainless steel flat head cap screws |
| Installation type | Cutting or drilling required |
Vehicle fitment
It is a direct fit for a Jeep body, and fit depends on the body style. Confirm your vehicle’s year, model and trim before ordering.
Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Installation requires cutting or drilling. The corners carry mounting holes for the factory flares, tail light and license plate frame, and the supplied hardware is stainless steel.
What’s included
Stock Crusher Corners in bare steel and the supplied stainless steel flat head cap screws.
Not included: any paint or coating, since the corners ship bare.









