Overview
The Poison Spyder Customs Standard Crusher Corners (Bare Steel), part number 14-04-020, are full rear corner armor in 3/16″ plate steel for the 1997–2006 Jeep Wrangler (TJ).
Poison Spyder Customs pre-configures the Standard Crusher Corners with its most popular features: a TJ-style wheel opening, provisions for flush-mounted LED taillights (sold separately), and the factory fuel filler opening. The corners are laser cut from high strength 3/16 inch plate steel and roll-formed to the Jeep’s body lines, with countersunk bolt holes. The supplied stainless steel flat head cap screws leave a smooth, flat surface for sliding over rocks. Flush-mount LED taillights are a common upgrade for a cleaner rear look. The Standard corners sit between the stock-opening version and the competition-cut version in the crusher corner line, combining the TJ-style opening with LED taillight provisions. The TJ-style wheel opening matches the factory flare line of the Wrangler TJ, so the Standard corners look closer to original than the competition cut.
Key features
- Full corner armor with a TJ-style wheel opening
- Provisions for flush-mounted LED taillights
- Factory fuel filler opening
- Laser cut from high strength 3/16″ plate steel
- Roll-formed to fit the body lines
- Countersunk bolt holes with stainless steel flat head cap screws
- Bare steel finish
Before you install
Full rear corner armor protects the quarter panels where rocks, stumps and tree trunks often make contact on a trail. Because the steel sits close to the body, the main concerns are fit at the wheel opening, clearance from the tire at full compression, and whether the fasteners hold after repeated impacts. Test fit the corner before drilling, and mark the bolt holes with the steel held in place so the countersinks line up with the body.
Bare steel will surface rust where it is scratched or where water sits against the edges. Apply a rust inhibiting primer to cut edges and any bare spots, then recheck the cap screws after the first few trail runs. If the corner rubs the tire or a rear fender, reshape the edge gently rather than forcing the panel against the body.
Owners running LED taillights should route the wiring away from moving parts and secure it along the body, which keeps the lights working through rough terrain.
- Test fit before drilling
- Prime all cut edges
- Recheck hardware after early trail use
Specifications
| Brand | Poison Spyder Customs |
|---|---|
| Part number | 14-04-020 |
| UPC | 614901725032 |
| Product type | Standard crusher corners (full rear corner armor) |
| Material | Steel plate, 3/16″ thick |
| Finish | Bare steel |
| Corner type | Full |
| Wheel opening | TJ-style |
| Hardware | Stainless steel flat head cap screws |
| Fitment type | Direct fit |
| Installation type | Cutting or drilling required |
Vehicle fitment
Poison Spyder Customs lists part number 14-04-020 for the Jeep Wrangler (TJ) from 1997 to 2006.
The LJ, YJ and CJ7 have different body lines and are not covered by this part number. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Plan on cutting or drilling during the install. LED taillights are not part of the kit, so wire any flush-mount LED units to a properly fused circuit and check local road-use rules.
What’s included
Full crusher corners with stainless steel flat head cap screws.
Not included: flush-mount LED taillights, which are sold separately.









