Overview
The Poison Spyder Stock Crusher Corners in bare steel (part number 13-04-010) are roll formed corner guards cut from 3/16 inch plate steel. They are built to match the body lines of the Jeep and to protect the corners from rock contact. The openings for the factory wheel and fuel filler are included, along with mounting holes for the factory flares, tail light and license plate frame.
The bolt holes are countersunk, so the supplied stainless steel flat head cap screws sit flush and leave a smooth surface that slides over rocks. The corners ship as bare steel.
Key features
- Roll formed to the body lines from 3/16 inch plate steel
- Openings for the factory wheel and fuel filler
- Mounting holes for factory flares, tail light and license plate frame
- Countersunk bolt holes that sit flush
- Smooth flat surface for sliding over rocks
Fitting bolt-on rock guards
Rock guards that bolt on need careful layout, because the mounting holes determine how the corner sits against the body. Mark each hole from the corner itself rather than the body panel, then drill and deburr before the first screw goes in. Flush screws help the guard slide over rocks instead of catching on them.
Once mounted, check the corner after each trail session for loose hardware or scuffs that show where the steel is rubbing. Fasteners can back off over time, so re-check their torque after the first outings. Corrosion often starts under the screw head, so inspect those spots regularly.
- Mark holes from the guard itself
- Deburr holes before installing screws
- Re-check fasteners after early trail use
- Look for scuffs at contact points
Specifications
| Brand | Poison Spyder Customs |
|---|---|
| Part number | 13-04-010 |
| UPC | 614901724004 |
| Type | Body corner guard, stock style |
| Corner type | Full |
| Material | 3/16 inch plate steel |
| Finish | Bare steel |
| Hardware | Stainless steel flat head cap screws |
| Installation type | Cutting or drilling required |
Vehicle fitment
Check the body fit against your Jeep’s year, model and trim before buying.
Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Installation requires cutting or drilling. The corners fit around the factory wheel and fuel filler openings and are mounted with the supplied stainless steel hardware.
What’s included
Stock Crusher Corners in bare steel and the supplied stainless steel flat head cap screws.
Not included: paint or a coating, since the corners ship bare.














