Overview
The Omix-ADA 18674.11 is a Dana 300 yoke seal, a direct OE replacement built to original Jeep specifications for CJ5, CJ7 and Scrambler vehicles from 1980 to 1986.
Use this seal when the yoke seal on a Dana 300 transfer case needs replacing. Match the model years and trims in the fitment section before ordering.
Key features
- Direct OE replacement built to original Jeep specifications
- Omix-ADA limited five year manufacturer warranty
- Direct fit for 1980–1983 CJ5, 1980–1986 CJ7 and 1981–1985 Scrambler
- Dana 300 yoke seal, part number 18674.11
Replacing a Dana 300 yoke seal
The yoke seal keeps lubricant inside the transfer case where the driveshaft yoke enters the housing. Leaks at this point usually show up as oil on the inside of the rear tire or as oil on the transfer case housing. Replace the seal when there is seepage, when the yoke shows a groove where the seal lip rides, or when the seal has been removed during a driveshaft or U-joint job.
Pull the yoke carefully so the seal bore is not scored, then clean the bore and check it for burrs. Lightly lubricate the new seal lip and install it squarely with a proper seal driver. Check the transfer case fluid level after the first few drives, because a freshly replaced seal can seep until it has seated fully.
Specifications
| Brand | Omix-ADA |
|---|---|
| Part number | 18674.11 |
| UPC | 804314045647 |
| Part type | Dana 300 yoke seal |
| Warranty | Limited five year manufacturer warranty |
Vehicle fitment
Fits the following Jeep models:
- 1980–1983 Jeep CJ5 (Base, Golden Eagle, Laredo, Limited, Renegade)
- 1980–1986 Jeep CJ7 (Base, Golden Hawk, Laredo, Limited, Renegade)
- 1981–1985 Jeep Scrambler (Base, Laredo, Renegade, SL, SR)
Other Jeep CJ years and models outside this list are not covered. Confirm your vehicle’s year, model and trim before ordering.
What’s included
The product is the Dana 300 yoke seal, part number 18674.11. No other included items are stated.









