Overview
The Omix-ADA 17905.01 is a heater/defroster control cable with a knob, made to replace the original cable on classic Jeep CJ5, CJ7 and Scrambler models. It is for the 1978–1983 CJ5, the 1978–1986 CJ7 and the 1981–1985 Scrambler.
Omix-ADA says its parts are built to original specifications. The cable type is heater/defroster, so it controls heater and defroster function rather than temperature or fresh air.
Key features
- Heater/defroster cable type
- Includes knob
- Built to original specifications.
- Limited five-year manufacturer warranty.
Heater defroster cable setup
A heater/defroster cable controls the air mix and defrost door that sends heat to the windshield. When it slips, the defrost setting may blow only partly to the glass, or the heat stays on the floor even with the lever at defrost. Because the door and the cable work together, check that the door moves fully before you assume the cable has failed.
Cables on these Jeeps often wear at the knob clip and the sheath end where the housing is held, so inspect those points during removal. Keep the new cable’s routing close to the original and avoid kinks, since a tight bend increases friction and makes the lever hard to move. Set the lever position with the engine off and the door in its detent before tightening the clamp.
Specifications
| Brand | Omix-Ada |
|---|---|
| Part number | 17905.01 |
| UPC | 804314037567 |
| Cable type | Heater/Defroster |
| Included hardware | Knob |
Vehicle fitment
It fits the 1978–1983 Jeep CJ5 (Base, Golden Eagle, Laredo, Limited, Renegade), the 1978–1986 Jeep CJ7 (Base, Golden Eagle, Golden Hawk, Laredo, Limited, Renegade) and the 1981–1985 Jeep Scrambler (Base, Laredo, Renegade, SL, SR).
Jeep Wrangler and pre-1978 CJ models are not in this list. Confirm your vehicle’s year, model and trim before ordering.
What’s included
Heater/defroster cable with knob.









