Overview
The Omix-ADA 16517.21 is an outer pinion bearing cup for the AMC Model 20 rear axle. Omix-ADA builds it as a direct OE replacement to the original Jeep specifications.
The fit covers the CJ-5, CJ-7 and Scrambler in the trims named above.
Key features
- Outer pinion bearing cup
- Made for the AMC Model 20 rear axle
- Direct OE replacement built to original specifications
Cup and bearing basics
The outer pinion bearing cup is the race that the bearing rolls against inside the AMC Model 20 carrier. A good cup seat holds the bearing square so the pinion runs straight and the gear teeth meet the way they were cut. Worn cups tend to show as pits, grooves or a dull, scuffed surface, and any of these can produce noise that changes with speed.
Cups are normally replaced in pairs with their bearings, since a new bearing on a worn cup wears quickly. When the carrier is open, clean the bore thoroughly and confirm the cup sits fully against the shoulder before assembly. Keep track of the shims used on the old setup, because the depth and preload checks depend on them.
- Replace the cup with its matched bearing
- Clean the bore and check the shoulder
- Note the shim stack before disassembly
Specifications
| Brand | Omix-ADA |
|---|---|
| Part number | 16517.21 |
| UPC | 804314023195 |
| Axle | AMC Model 20 |
| Axle location | Rear |
| Component | Outer pinion bearing cup |
Vehicle fitment
It fits the 1976–1983 Jeep CJ-5 (Base, Golden Eagle, Laredo, Limited and Renegade), the 1976–1986 Jeep CJ-7 and the 1981–1985 Jeep Scrambler.
The Cherokee, Wagoneer and Wrangler models are not in the list.
Confirm your vehicle’s year, model and trim before ordering.
What’s included
One outer pinion bearing cup, Omix-ADA part number 16517.21.









