Overview
The Omix-ADA 18606.06 is a twin stick shifter boot for Dana 300, Dana 20 and Dana 18 transfer cases. It fits 1980–1986 Jeep CJ7, 1980–1983 Jeep CJ5 and 1981–1985 Jeep Scrambler models.
Omix-ADA built the boot to original specifications and it carries a limited five year warranty.
Key features
- Twin stick design for Dana 300, Dana 20 and Dana 18 transfer cases
- Built to original specifications
- Carries a limited five year warranty
- Omix-ADA part number 18606.06
Care and inspection
A shifter boot keeps dirt, water and grit out of the opening where the shift lever enters the transfer case cover. On a twin stick setup, the boot sits around the shift levers and flexes each time the driver moves between high and low range or engages four-wheel drive. A torn boot lets trail mud work into the linkage and can wear the shift shafts over time, so it is worth checking at every fluid service or after a deep water crossing.
When inspecting an older boot, look for cracks along the folds, stiffness, and gaps where the boot meets the cover. Replace it if it no longer seals. Many owners replace the boot alongside the shift linkage bushings and any worn shift levers, since those parts see the same dirt and heat. Clean the mating surface before fitting the new boot so it seals evenly, and check that the levers move freely through all positions afterward.
Specifications
| Brand | Omix-Ada |
|---|---|
| Part number | 18606.06 |
| UPC | 804314078836 |
| Shifter type | Twin stick |
| Compatible transfer cases | Dana 300, Dana 20, Dana 18 |
Vehicle fitment
It fits the 1980–1983 Jeep CJ5, the 1980–1986 Jeep CJ7 and the 1981–1985 Jeep Scrambler. Other years and Jeep models fall outside that fit.
Years outside these ranges and other Jeep models are not in this list. Confirm your vehicle’s year, model and trim before ordering.
What’s included
Check the package contents against your installation before starting.
















