Overview
The Omix-ADA 18606.01 is a rubber dual lever shifter boot for the Dana 18 transfer case. It fits Jeep CJ3, CJ5 and CJ6 models and Willys CJ-2, CJ-3, CJ-5 and CJ-6 models.
It is built to original specifications and is covered by a limited five year warranty from Omix-ADA.
Key features
- Dual lever design for the Dana 18 shifter
- Rubber construction
- Built to original specifications
- Limited five year warranty from Omix-ADA
Dana 18 shifter boot upkeep
A dual lever shifter boot seals the gap around both levers so grit and water stay away from the transfer case linkage. Because the boot flexes with every shift, the rubber can crack near the folds, and the mounting edge can pull away from the floor. Replacing a split boot early prevents damage to the shifter pivots.
When fitting a new boot, clean the shifter base and check the lever pivots for play. Dust that gets in while the boot is off can speed up wear, so work in a clean area. Rubber softens with heat, so store a spare boot out of direct sunlight and inspect the seal after any off-road trip through deep water or mud. Keep the mounting hardware with the boot so nothing is lost during installation.
Specifications
| Brand | Omix-Ada |
|---|---|
| Part number | 18606.01 |
| UPC | 804314013127 |
| Material | Rubber |
| Lever type | Dual lever |
| Transfer case | Dana 18 |
Vehicle fitment
It fits Jeep CJ3 (1959–1960, 1966), Jeep CJ5 and CJ6 (1959–1960, 1966–1971), and Willys CJ-2 (1946–1949), CJ-3 (1949–1958), CJ-5 (1955–1958) and CJ-6 (1956–1958) models.
Jeep CJ7 and later models, and Jeep models from 1972 on, are not in this list. Confirm your vehicle’s year, model and trim before ordering.
What’s included
Check the package contents against your installation before starting.









