Overview
The Warrior 90440PC is a black powder coat aluminum diamond plate shifter cover for the Dana 300 transfer case, made to fit 1980–1986 Jeep CJ7 models.
The cover is a factory replacement that uses the original mounting holes. It is designed for T4 and T5 transmissions with a 4 cylinder engine, and it does not include rubber gearshift boots.
Key features
- Black powder coat finish
- Aluminum diamond plate construction
- Direct factory replacement for the original mounting holes
- Covers do not include rubber gearshift boots
Before you install
A shifter cover protects the shift opening from dirt, water and debris while leaving the linkage accessible. On a CJ7 with a Dana 300 transfer case, the cover sits at the top of the floor area where the shifter boots would normally seal, so the boot choice matters. Many owners who fit a cover also replace the boots at the same time, since an old boot can tear once the opening is exposed.
Before installing, inspect the mounting surface for rust or bent metal. A flat, clean surface helps the cover seat evenly. Check that the transmission and transfer case combination matches the T4 or T5 and Dana 300 setup before you start, because shifter openings and linkage differ between configurations.
- Inspect the mounting holes for corrosion before bolting the cover down
- Replace worn gearshift boots at the same time if your setup uses them
- Check shifter travel and linkage clearance after the first drive
- Keep the diamond plate clean to limit moisture trapped underneath
Specifications
| Brand | Warrior |
|---|---|
| Part number | 90440PC |
| UPC | 634146904429 |
| Color | Black |
| Material | Aluminum diamond plate, black powder coat |
| Transfer case | Dana 300 |
| Transmission | T4/T5 |
| Engine | 4 cylinder |
Vehicle fitment
It fits the 1980–1986 Jeep CJ7 in Base, Golden Hawk, Laredo, Limited and Renegade trims.
Other Jeep models and years are not in this list. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
No drilling is required, because the cover uses the original mounting holes.
What’s included
The shifter cover.
Not included: Rubber gearshift boots.









