Overview
The Omix-ADA 18674.19 is a Dana 300 input shaft oil seal and a direct OE replacement for Jeep vehicles. It is built to the original specifications of the part it replaces and fits the Jeep CJ5, CJ7 and Scrambler.
This seal comes with a limited five year warranty.
Key features
- Direct OE replacement built to original specifications
- Dana 300 transfer case input shaft seal
- Limited five year warranty
- Omix-ADA part number 18674.19 and UPC 804314045777
Transfer case seal care
The input shaft seal keeps transfer case lubricant from leaking out where the input shaft passes through the case. A worn seal often shows as oil on the transfer case housing, the bellhousing face or the lower edge of the transmission, and the drip can be mistaken for a leak from elsewhere. Clean the area thoroughly before inspecting so you can see where the fluid is actually coming from.
When the seal is replaced, the input shaft surface should be checked for grooves or pitting that could cause a new seal to leak. Fluid level should be confirmed afterward, and the vehicle should be checked for leaks after a short drive. Older Jeep drivelines often show wear in nearby parts, so inspect the front yoke and shifter linkage while the transfer case is accessible.
Specifications
| Brand | Omix-ADA |
|---|---|
| Part number | 18674.19 |
| UPC | 804314045777 |
| Transfer case | Dana 300 |
| Seal location | Input shaft |
| Warranty | Limited five year warranty |
| Fitment type | Direct fit |
Vehicle fitment
Fits the 1980–1983 Jeep CJ5, 1980–1986 Jeep CJ7 and 1981–1985 Jeep Scrambler, each with its factory trims.
Other Jeep models are not among the covered vehicles. Confirm fit for your vehicle’s year, model and trim before ordering.
Installation notes
The input shaft seal is reached at the transfer case, so the vehicle must be raised on stands for the work.
What’s included
Check the package contents against your installation before starting, and have any gasket or hardware your rebuild calls for on hand.
