Overview
The Crown Automotive 5019020AA is a front retainer seal for NP231 and NP242 transfer cases. It fits 2002–2006 Dodge Ram 1500, 2500 and 3500 trucks, plus Jeep Grand Cherokee (WJ), Liberty (KJ), Wrangler (TJ), Wrangler (JK) and 2018 Wrangler (JL) models.
Key features
- Front retainer seal for NP231 and NP242 transfer cases
- Fitment includes Dodge Ram and several Jeep models
- The Wrangler JL entry covers 2018 only
- Identified by part number 5019020AA and UPC 848399033496
Before you replace the seal
A front retainer seal sits where the transfer case output area meets the housing, and its job is to hold lubricant in while the shaft turns. Over time the lip hardens or wears, and a seep at the front of the case is often the first sign. Fluid collecting on the lower front of the transfer case, or dripping near the front driveshaft yoke, points toward this seal rather than a gasket elsewhere.
Because the seal is pressed into a bore, the condition of that bore matters as much as the seal itself. Look for scoring or old sealant before pressing in a new one, and keep the surface clean and free of debris. Transfer case fluid should be checked after the job, since a fresh seal does not correct a low level that was already there.
- Check the front yoke surface for grooves that could wear a new lip
- Replace the seal when it is already leaking rather than as a routine swap
Specifications
| Brand | Crown Automotive |
|---|---|
| Part number | 5019020AA |
| UPC | 848399033496 |
| Part type | Front retainer seal |
| Application | NP231 and NP242 transfer cases |
Vehicle fitment
It fits 2002–2006 Dodge Ram 1500, 2500 and 3500 trucks in several trims, 2002–2004 Jeep Grand Cherokee (WJ), 2003–2007 Jeep Liberty (KJ), 2007–2018 Jeep Wrangler (JK), 2018 Jeep Wrangler (JL) and 2003–2006 Jeep Wrangler (TJ).
Dodge Ram and Jeep years outside the entries above are not covered. The 2018 Wrangler (JL) entry covers only 2018, so later JL years are not on this list. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Seal replacement means opening the front area of the transfer case, so clean the bore and check the seal’s position before fitting the new seal. Use a seal driver rather than a hammer.
What’s included
Front retainer seal, part number 5019020AA.
Not included: Other transfer case gaskets and hardware are not part of this item.









