Overview
The Omix-Ada 18037.01 is a front upper ball joint, part number OAI18037.01, for older Jeep CJ and Wagoneer models. It fits the 1972–1983 CJ5, the 1972–1975 CJ6 and the 1976–1986 CJ7, plus the 1974–1983 Wagoneer (SJ), the 1984–1991 Grand Wagoneer (SJ) and the 1981–1985 Scrambler.
It is a direct OE replacement built to original specifications. It is an upper joint for the Dana 30 standard front axle and is not lubeable, so it has no grease fitting to service.
Key features
- Upper position for the front suspension
- Dana 30 standard front axle application
- Includes nut, adjusting sleeve, cotter pin and grease.
- Built to original specifications.
Replacing an upper joint
Upper ball joints on older Jeep front ends work with the lower joint and the control arms to let the wheel steer and move up and down. When a joint wears, the wheel can wander, the steering can feel loose, or the tire can wear unevenly along one edge. Check for play by lifting the wheel and looking for movement at the joint, and inspect the boot for tears before deciding whether to replace it.
Because the upper and lower joints share the load, many owners replace both on the same side when one is worn, and the alignment should be checked after any joint is changed. Keep the nut, adjusting sleeve and cotter pin together during installation, and confirm the sleeve setting against a factory procedure in a service manual before the wheel goes back on.
- Check for play at the joint with the wheel lifted
- Look for torn boots and uneven tire wear
- Replace in pairs on the same axle side when both are worn
Specifications
| Brand | Omix-Ada |
|---|---|
| Part number | OAI18037.01 |
| Position | Front upper |
| Axle location | Front |
| Axle type | Dana 30 Standard |
| Lubeable | No |
Vehicle fitment
It fits the 1972–1983 Jeep CJ5 (Base, Golden Eagle, Laredo, Limited and Renegade), the 1972–1975 CJ6 (Base), the 1976–1986 CJ7 (Base, Golden Eagle, Golden Hawk, Laredo, Limited and Renegade), the 1984–1991 Grand Wagoneer (SJ), the 1981–1985 Scrambler and the 1974–1983 Wagoneer (SJ).
Jeep models outside those years and names, including the Wrangler, are not on this list. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
The nut, adjusting sleeve and cotter pin are supplied with the joint, so the securing parts do not need to be sourced separately. The joint is not lubeable, so it has no grease service.
What’s included
One upper ball joint with a nut, adjusting sleeve, cotter pin and grease, part OAI18037.01.









