Overview
The G2 Axle and Gear 35-2051 is a front master ring and pinion installation kit for the Dana 44 on the Jeep Wrangler JK Rubicon. It fits the Rubicon front axle, and the JK is covered by its chassis code, which spans the 2007 through 2018 Wrangler JK years.
Master kits cover the whole ring and pinion job, including bearings. This kit includes Timken inner and outer pinion bearings and races, carrier bearings and races, a pinion nut, pinion seal, crush sleeve, shims for pinion and carrier, ring gear bolts, thread locking compound, gear marking compound and silicone sealer.
Key features
- Master kit with bearings for the front Dana 44
- Timken inner and outer pinion bearings with races
- Carrier bearings and races
- Crush sleeve, pinion nut and pinion seal
- Pinion and carrier shims with new ring gear bolts
Before the front gears go in
A ring and pinion swap is the point where a front axle gets its gear set rebuilt from the carrier outward. Worn pinion bearings, a loose pinion nut, or a noisy gear set at speed are common signs that the front gears need attention. Once the carrier is out, the bearing races and seals are easiest to replace at the same time.
Setting up the new gears is more than bolting parts together. Pinion depth and carrier preload work together, and the shim stack determines where the tooth contact sits. Plan for the marking compound and a few test passes before the cover goes back on. Keep the shims sorted by thickness so you can reuse the exact stack if you have to back out a change.
If you run locking hubs or an upgraded front locker, check their condition during the rebuild, because the carrier is already open. Fresh gear oil and a clean cover gasket help the new set last.
- Keep shims sorted by thickness
- Check the marking pattern before final assembly
Specifications
| Brand | G2 Axle and Gear |
|---|---|
| Part number | 35-2051 |
| UPC | 631410096002 |
| Axle location | Front |
| Axle type | Dana 44 JK |
| Kit type | Master kit with bearings |
| Application | Rubicon front only |
| Bearings | Timken pinion inner and outer, carrier bearings and races |
Vehicle fitment
It fits the front Dana 44 on the Jeep Wrangler JK Rubicon, covering 2007 through 2018 model years.
The rear Rubicon and non-Rubicon rears use other master kits. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
The kit includes bearings, so the front carrier is rebuilt with new races. Gear set setup depends on shim thickness and tooth contact, so use the gear marking compound to check the pattern while setting the shims.
What’s included
Pinion nut, pinion seal, Timken outer and inner pinion bearings with races, crush sleeve, pinion shims, carrier shims, carrier bearings and races, ring gear bolts, thread locking compound, gear marking compound and silicone sealer.




