Overview
The G2 Axle and Gear 35-2012A is a master ring and pinion installation kit with bearings for the Ford 9.75-inch axle, for the rear axle position.
The 35-2012A contains the parts needed to install a ring and pinion properly, with pinion bearings and carrier bearings along with the shims, nut, seal and compounds. Some of these parts are hard to find and rarely stocked by auto parts stores. It is for use in 2000 and newer axles only. The ring and pinion gear set itself is not included.
Key features
- Master kit with bearings for the Ford 9.75-inch axle
- Timken outer and inner pinion bearings and races
- Pinion shims and carrier shims
- Carrier bearings and races included
- Pinion nut, crush sleeve, pinion seal and ring gear bolts
- Thread locking compound, gear marking compound and silicone sealer
- For use in 2000 and newer axles only
Identifying your axle
The Ford 9.75-inch axle has changed over the years, so the build date and the ring gear and carrier details matter when matching a kit. Before buying, measure or read the axle tag, then compare it with the year restriction on this kit. A correct identification avoids returning gears that do not match the carrier or the pinion splines.
Once the axle is identified, plan on replacing the pinion and carrier bearings together with the gear set. Clean the housing thoroughly and check for metal debris, since small particles can damage new bearings quickly. Use the gear marking compound to verify tooth contact before final assembly.
- Read the axle tag before ordering
- Match the ring gear to the carrier
- Clean the housing thoroughly before assembly
Specifications
| Brand | G2 Axle and Gear |
|---|---|
| Part number | 35-2012A |
| UPC | 631410095579 |
| Product type | Master ring and pinion installation kit with bearings |
| Axle | Ford 9.75-inch |
| Axle location | Rear |
| Popular axle manufacturer | Ford |
| Kit type | Master kit with bearings |
| Listing condition | For use in 2000 and newer axles only |
| Contents | Pinion nut, pinion seal, Timken outer pinion bearing and race, crush sleeve, Timken inner pinion bearing and race, pinion shims, carrier shims, carrier bearings and races, ring gear bolts, thread locking compound, gear marking compound, silicone sealer |
Vehicle fitment
The 35-2012A is identified by axle rather than by vehicle: it is made for the rear Ford 9.75-inch axle, and only for 2000 and newer axles. Check your axle’s build date before ordering.
It is not made for other axle designs or sizes, so identify your rear axle before ordering.
Installation notes
A master kit such as the 35-2012A rebuilds the gear setup completely, so the bearings are replaced along with the gear set. The pinion shims, carrier shims, crush sleeve and gear marking compound in the 35-2012A are the parts used to set pinion depth, preload and the tooth contact pattern, which calls for an installer with gear setup experience and a careful break-in afterwards.
What’s included
- Pinion nut
- Pinion seal
- Timken outer pinion bearing and race
- Crush sleeve
- Timken inner pinion bearing and race
- Pinion shims
- Carrier shims
- Carrier bearings and races
- Ring gear bolts
- Thread locking compound
- Gear marking compound
- Silicone sealer
Not included with the 35-2012A: ring and pinion gear set.







