Overview
The Fabtech FTL5303 is a 2 inch front coil spacer lift for Ram 2500 and 3500 trucks with a radius arm front suspension. The kit includes spacers and hardware, and the lift height is 2 inches.
The kit is designed for radius arm front suspension, so confirm your truck uses that setup before ordering. It fits the 2003-2010 and 2011-2013 Ram 2500 and the 2003-2010 and 2011-2012 Ram 3500.
Key features
- Angled coil spacers, which Fabtech says keep the factory coil springs’ large bow for stability and handling
- Longer length front shocks for full suspension travel and better damping
- Extended length bump stops that prevent the coils from binding at full compression
- It is designed to eliminate trac bar interference.
- Front position, 2 inch lift
Radius arm trucks and ride
Radius arm front suspension locates the axle with long arms, and a coil spacer lift keeps those arms in their original geometry while raising the front. The angled spacer design is meant to preserve the stability of the factory coil springs, which matters on heavier trucks. Because the spring sits higher, the shock and bump stop must reach farther to control the axle through its travel.
Longer shocks are not a cosmetic change. They restore damping across the new suspension range, so a shock that is worn or too short can bottom out or feel loose on rough roads. Replace the front shocks together rather than one at a time, and check the trac bar and its brackets for wear during installation. Recheck the bolts after the first drives and schedule an alignment once the install is complete.
- Inspect the trac bar and mounting brackets
- Replace front shocks as a matched pair
- Check bump stop clearance at full compression
- Confirm wheel clearance after the lift
Specifications
| Brand | Fabtech |
|---|---|
| Part number | FTL5303 |
| UPC | 674866098046 |
| Lift | 2 inches, front |
| Suspension | Radius arm front suspension |
| Included | Spacers and hardware |
| Wheel backspace | 4 5/8 inch (20 x 9.5 inch wheel: 5 inch) |
Vehicle fitment
Check that your truck’s year and trim match the covered range before buying.
Check the instructions for your model year before starting the installation.
Installation notes
The kit includes extended bump stops and longer front shocks, so the front shocks should be replaced as part of the install. Wheel alignment is needed afterward.
What’s included
Included: spacers and hardware, with longer front shocks and extended bump stops.









