Overview
The Dorman 689-201 is a camshaft synchronizer for the 4.0L 6 cylinder engine that drives the oil pump. It comes as a kit with a new camshaft position sensor. It is a direct fit for 2005–2006 Jeep Wrangler (LJ and TJ) models.
The kit is more than a single part, so check each component against your installation before starting. Check the UPC and installation steps against your service procedure as well.
Key features
- Includes a new camshaft position sensor
- Camshaft synchronizer for the 4.0L 6 cylinder engine
- Drives the engine oil pump
- Direct fit for 2005–2006 Wrangler (LJ and TJ) models
Camshaft sensor and timing
The camshaft position sensor tells the engine computer where the camshaft is in its rotation, which is needed for accurate ignition and fuel timing. A failing sensor can cause rough running, stalling or a no-start condition. Replacing it at the same time as the synchronizer keeps the timing reference fresh and avoids a second repair.
Synchronizers and sensors wear slowly, so check for oil leaks around the sensor, a loose connector and cracked wiring when the old parts come out. Use a new sensor seal, clean the mounting face and tighten the fasteners to the correct value. Careful routing of the sensor harness keeps it away from hot exhaust parts.
- Clean the sensor mounting face before fitting
- Check the wiring harness for chafing
- Clear fault codes and test drive after installation
Specifications
| Brand | Dorman |
|---|---|
| Part number | 689-201 |
| Engine | 4.0L 6 cylinder |
| Included | Camshaft synchronizer and camshaft position sensor |
Vehicle fitment
It fits 2005–2006 Jeep Wrangler (LJ) Unlimited and Unlimited Rubicon models, and 2005–2006 Jeep Wrangler (TJ) 65th Anniversary Edition, Rubicon, SE, Sport and X models.
Wrangler (LJ) and (TJ) years before 2005, and Wrangler (JK) models, are not on this list. Confirm your vehicle’s year, model and trim before ordering.
What’s included
The kit includes the camshaft synchronizer and a new camshaft position sensor.











